Monster iCarPlay User Manual & Warranty Information

iCarPlay Wireless 200
™
Car Stereo FM Transmitter/Charger
User Guide & Warranty Information
iCarPlay Wireless 200 Features
™
• High-quality stereo audio
• Full range of FM stations, from 88.1
to 107.9 (U.S. mode)
• 3 "favorite station" programmable presets
• iPod screen display of FM frequency
®
• AutoScan automatically finds best FM frequency
• 30-ft. maximum range**
• Micro-processor controlled
• Built-in antenna
• Powered by 12V car cigarette lighter adapter
• International FM tuning for U.S., Europe,
and Japan
• Auto-reset fuse to protect unit and iPod
• Charges iPod while in use
**Range determined by product specifications and other environmental variables
Setting Memory Presets
You can program the 3 FM Station Memory Presets
to any frequencies in the FM range. iCarPlay Wireless
200 will continue to remember these presets even
when both power and the iPod are disconnected,
so they'll always be ready to use the next time
you need them.
1. Press the "S" button TWICE. (This will stop music
playback on the iPod.)
iPod
89.1
����
� � �
2. Press the Right or Left button to highlight the FM
Station Memory Preset that you'd like to change.
iPod
OK to disconnect.
89.1
� � � ����
3. Press and hold the "S" button for two seconds
to enter Preset tuning.
iPod
OK to disconnect.
89.1
Preset 2
INSTRUCTIONS
Connecting to iPod and Car
1. Plug the iCarPlay
Wireless 200
power adapter
into your car's 12V
accessory outlet
(cigarette lighter
socket) and turn
your iPod on.
2. Plug the iCarPlay Wireless
200 dock unit into your iPod
docking connector. The iPod
screen will flash the check
symbol and the words
"OK to disconnect,"
and then iPod will revert
back to the regular
iPod menu.
4. Press Right or Left to scroll tune the desired
FM frequency displayed on the iPod screen.
5. Press the "S" button again. The FM Station Memory
Preset will be set, selected, and the iPod will return
to its regular menu.
Selecting Memory Presets
The iCarPlay Wireless 200 features 3 FM Station
Memory Presets to make it easy for you to quickly
select commonly used channels that you can set
(see next section). You may find, for example,
that one frequency works best in one part of town
and another works better elsewhere.
1. Press the "S" button twice. (This will stop music
playback on the iPod.)
2. Press Right or Left button to select the desired
preset frequency.
iPod
89.1
� � � ����
3. Press the "S" button to select.
4. Tune your FM radio to the same channel
as indicated on the iPod display screen.
OK to disconnect.
Manual Tuning
1. Press the iCarPlay
Wireless 200 "S"
button ONCE.
(This will stop
music playback
on the iPod.)
����� �
2. Press Right or Left button to select FM frequency.
����� ���� ����� �����
����� �� ����� ��
���� ���� ���� ��
Using AutoScan Automatic
FM Frequency Selection
(recommended)
The iCarPlay Wireless 200 features AutoScan
to automatically find the best, clearest FM channel
in your local area. The process takes about a minute.
Remember that as you drive through different areas
the FM signal conditions change, so when driving
long distances, you can repeat the AutoScan selection
whenever FM interference occurs.
1. Press TWICE on the "S" button. (This will also stop
music playback on the iPod.)
2. Press the Right or Left button to highlight AutoScan
and press the "S" button to select.
iPod
89.1
� � � ����
3. AutoScan will begin searching through the entire
FM range to find the best frequency. This may take
up to 1 minute. Then iCarPlay Wireless 200 will
OK to disconnect.
automatically select the best frequency and display
it on the iPod screen. NOTE: After a few seconds
3. Press the "S"
button again.
The iPod will
return to its
regular menu.
����� �
4. Tune your FM radio to the same channel.
the iPod will return to its regular menu,
so it's important to note the AutoScan
selected frequency while it's shown.
4. Tune your FM radio to the same channel.
AutoScan Shortcut
To use AutoScan without selecting from menu,
simply hold the "S" button until it says "scanning"
International Use
iCarPlay Wireless 200 works with FM radio systems
worldwide. To select a different tuning system:
1. Press the "S" button THREE TIMES. (This will
stop music playback on the iPod.)
iPod
Region
N. America
Japan
Europe
2. Press the Right or Left to select the desired
International Mode.
OK to disconnect.
• N. America: 88.1 - 107.9 MHz (with 0.2 intervals)
5. Press the "Play" button
on your iPod.
6. Use your car radio's volume knob to adjust
sound level.
������
• Japan: 76 - 90 MHz (with 0.1 intervals)
• Europe: 87.8 - 108.1 MHz, (with 0.1 intervals)
3. Press the "S" button again. The International
Mode will be set, and the iPod will return
to its regular menu.
Note: iPod Backlight Timer Setting
• Depending on your settings, your iPod's screen
light may go out before you're finished making
adjustments to the iCarPlay Wireless 200.
To ensure uninterrupted iPod screen viewing
during setup and FM frequency selection,
please set the backlight timer properties
on the iPod settings menu to your preference
while using iCarPlay Wireless 200.
• The words "OK to disconnect" will always appear
when in FM Transmitter mode; this is normal.
• When selecting your FM station, in all instances,
the music will stop transmitting.
Please see reverse for important performance
and safety tips.