• Designed for use with 8 ohm speakers Modes of Operation The SS-4.2 and SS-6.2 may be used in one of two modes of impedance match- ing: (Please note: impedance matching is required, but only once in the system.) With internal impedance matching (Impedance switch set to “IN”) This method of impedance matching uses the SS-4.2/6.2’s internal high-pow-...
Using 4-conductor speaker wire (16-12 gauge), connect the first pair of speak- ers to the Speaker 1 inputs on the SS-4.2/6.2. Strip off 1/4” of insulation from the wire and tightly twist the copper conductor to eliminate loose or frayed ends.
Page 4
Speakers Speaker wire OUTPUT OUTPUT ALTx IMPEDANCE Impedance Matching Volume Control BYPASS INPUT INPUT Speaker wire SS-6.2 IMPEDANCE BYPASS , NH, U.S.A. AMPLIFIER EWMARKET Speaker wire 4 - 8-ohm Stable Amplifier SPEAKER 1 ~120VAC ~60Hz SPEAKER 2 Conforms to THIS UNIT MUST BE UL 6500 Tested to Comply SS-6...
Page 5
Speakers IMPEDANCE BYPASS Speaker wire SS-6.2 IMPEDANCE BYPASS , NH, U.S.A. AMPLIFIER EWMARKET Speaker wire 4-ohm Stable Amplifier SPEAKER 1 ~120VAC ~60Hz SPEAKER 2 Conforms to THIS UNIT MUST BE UL 6500 Tested to Comply SS-6 EARTH GROUNDED Certified to with FCC Standards CSA C22.2 No1-94 68835...
Room Labels Choose the appropriate room label from the included label sheet and place it above the appropriate switch on the front panel of the SS-4.2/6.2. The labels are non-adhesive and slide into a groove machined into the aluminum front panel.
Page 7
To return for repairs, the unit must be shipped to Russound at the owner's expense, along with a note explain- ing the nature of service required. Be sure to pack the unit in a corrugated con- tainer with at least three (3) inches of resilient material to protect the unit from damage in transit.