American Standard Cadet 3011.016 Features & Dimensions

TROPIC CADET 3 ROUND FRONT TOILET
®
❑ 2455.016
• Vitreous china
• EverClean surface inhibits the growth of
®
stain- and odor-causing bacteria, mold,
and mildew on the surface
• Low-consumption (6.0 Lpf/1.6 gpf)
• Features the Cadet
• Space saving round front siphon action
jetted bowl
• Fully-glazed 2-1/8" trapway with 2" ball pass
• Generous 9" x 8" water surface area
• Close-coupled tank with flat tank cover for
superior storage
• Oversized 3" flush valve with chemical
resistant flapper
• Chrome trip lever
• Speed Connect tank-to-bowl coupling system
®
• Sanitary dam on bowl with four point
tank stabilization
• 2 color-matched bolt caps
• 100% factory flush tested
• 5 year warranty
❑ 3011.016 Round Front Bowl
❑ 4007.016 Tank
Nominal Dimensions:
718 x 476 x 740mm (28-1/4" x 18-3/4" x 29-1/8")
Fixture only, seat and supply by others
Alternate Tank Configurations Available:
❑ 4007.516 Tank complete with Aquaguard Liner
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.2M for Vitreous China Fixtures -
includes Flush Performance, Ball Pass Diameter,
Trap Seal Depth and all Dimensions
• Los Angeles Department of Water and Power
Supplementary Purchase Specification for
Non-Adjustability
To Be Specified:
❏ Color: ❏ White ❏ Bone ❏ Silver ❏ Linen ❏ Black
❏ Seat: #5330.010 Round front Champion
solid plastic seat and cover with easy lift off feature
❏ Seat: #5282.011 Round Front EverClean
tic seat and cover
❏ Seat: #5320.110 EverClean
Slow Close Snap-Off Hinges
❏ Supply with stop:
© 2008 AS America Inc.
3 Flushing System
®
Slow Close
®
®
solid plas-
®
Round Front Seat with
ROUND FRONT TOILET
718mm
(28-1/4)
FINISHED WALL
25mm ± 6mm
(1 ± 1/4)
235mm
(9-1/4)
416mm
(16-3/8)
C/L OF SEAT POST HOLES
140mm (5-1/2 CENTERS)
216mm 333mm
(8-1/2) (13-1/8)
305mm C/L OF OUTLET
(12)
NOTES:
THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF
305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.
SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.
*
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range
of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility is
assumed for use of superseded or voided pages.
K53
TROPIC CADET
VITREOUS CHINA
476mm
(18-3/4)
SUPPLY
AS
REQ'D.
*381mm
(15)
*203mm 352mm
(8) (13-7/8)
235mm
(9-1/4)
FINISHED
FLOOR
*152mm
Revised 2/08
3
®
740mm
(29-1/8)
(6)