Frigidaire FAC102P1A4 Installation Instructions

÷
u m
READ BEFORE iNSTALLiNG UNIT
Compact ni Window Mounting
Your ah"conditioner is designed to install in skmdard
double llm_g windows with opening widths of 22 to 36
inches (559 mm to 914 ram) (FIG. l)
Lower sash must open sufficiently 1o allow a clear velltical
opeuing of 14-1/2 inches (368 rnm). Side loovers and the
rear of the AC most have clear air space to allow
enoogh airflow throogh the condensel; for heat removal.
The rear of' the onit most be ootdoors, not inside a
boilding or garage.
NOTE: SAVE CARTON aud these INSTALLA-
TION INSTRUCTIONS tbr furore reference. The caJlon is
the best way to store unit during winter, or when not hi use,
When handling unit, be careful to avoid cuts
from sharp metal edges and aluminum fins on
front and rear coils.
Befbre installing the unit, the Left-Hand
Louver must be assembled to the unit:
A. Carefully remove power supply
cord flx)m air discharge area
(Fig. A).
B. Carefully remove dte Left-Hand
Louver Assembly from the
discharge area, and theu remove
it fl:om the plastic bag(Fig. B).
C. With care, pry apaJl tile auger
wheel shaft fl:om tile horizontal
k)uver casing, as shown hi Fig.
C,D&E.
Some assemNy is required. Please read these instructions
÷
Mounting Hardware
3/4 'screws
lock frame
sash lock
TOOLS NEEDED:
* Drill (If pilot hales are needed)
Qty.
7
D. Now locate tile auger wheel
shaft into tile vertical ceuter
post (Fig. F).
E. Clip the oilier end hllo tile
locating slot.
E Now place the horizontal louver
casing onto the auger wheel
shaft, and snap in place (Fig.
G).
G,
Check tile operation by moving
tile horizontal louver up and
down, and theu turn file auger wheel so file vertical
kmvers rotate.
SZOOO357(En) 1 , 10/21/2004, 10:42 AM