Advertisement
Quick Links
USER MANUAL
OUTBOARD MOTOR BRACKETS
Aluminum Outboard Motor Brackets - Installation and Operating Instructions
T10050, T10051, T10052 and Quick Connect/Adaptor Plate T10053
Models
CAUTION
Do not exceed the bracket's HP or weight limits. Read instructions completely before starting assembly.
Motor bracket must remain in the "UP" position throughout installation. DO NOT operate motor
bracket unless motor is installed on bracket. This bracket is under spring tension. Exercise caution
when installing and operating.
INSTALLATION INSTRUCTIONS
Refer to Figures 1 and 2
Measure the distance on your outboard motor between the cavitation plate and the upper inside edge
of the transom clamp. Add the total travel distance of your model bracket from the table in figure 1.
Then subtract 2 inches.
(Measure clamp to cavitation plate) add (bracket's vertical travel) subtract 2" = _________
Cut a stick to this length and tape it to the center of the bracket board so that the stick and board are
flush at the top edge of the board as shown in figure 2.
Advertisement
Summary of Contents for TRAC T10050
- Page 1 USER MANUAL OUTBOARD MOTOR BRACKETS Aluminum Outboard Motor Brackets - Installation and Operating Instructions T10050, T10051, T10052 and Quick Connect/Adaptor Plate T10053 Models CAUTION Do not exceed the bracket’s HP or weight limits. Read instructions completely before starting assembly. Motor bracket must remain in the “UP” position throughout installation. DO NOT operate motor bracket unless motor is installed on bracket.
- Page 2 Refer to Figure 3 Choose the most appropriate side of your transom for installing the bracket. Position your bracket so it won’t interfere with the turning operation of your primary motor, rudder, or anything else installed on your boat’s transom. Power Boats –...
- Page 3 Refer to Figure 7 If the transom is less than 2" thick, a backing plate should be installed on the inside of the transom for greater needed rigidity. Attach your motor bracket to the transom by coating the flat surfaces of the mounting flanges, the backing plate, and both sides of the drilled holes with a marine adhesive/sealant.
- Page 4 (not refurbished) TRAC Outboard Motor Bracket. This limited warranty is not transferable to any other party. TRAC will at it option repair or replace any part of the TRAC Outboard Motor Bracket which may be found by TRAC to be defective within two (2) years of original purchase.