ALCATECH BPM STUDIO 4 PRO User Manual page 109

RCP-1001 Description
If you would like to play the title immediately, then
load it directly to the Player by double click. The
just selected group or title will be shown in the
display [14] during the selection using the Jog
Shuttle Wheel. Therefore the Archive can be
operated without looking constantly at the monitor.
You can move back to the Search mode by
pressing the [ARCHIVES] or [P.List] key [16, 17]
anew. The Archive mode ends automatically after
10 seconds without any entry.
[4] Cue Button
Pressing this key moves the player back to the
last Cue-Point and goes into Cue mode.
Press the Cue key longer than one second and
the player then moves to the beginning of the
title or by pressing one second again will move it
to the current Cue-Point.
[5] Play Button
Pressing this key starts the player from the current
position (i.e. the Cue-Point). If the Play button is
pressed again, the player goes into Pause Mode.
The current start position of the player (before
any anew pressing on the Play key is made) is
stored as a Cue-Point and can be started again
with the [Cue] key any time.
[9] Pitch-Bend Buttons
Using these keys, you can temporarily increase
or decrease the play speed. These keys are an
indispensable tool for synchronizing the second
title's Beats. They are used to navigate by Beat
in a title, if the Player is in Cue Mode (see also
chapter 'Beat stepping using BPM Studio').
[10] Pitch Slider
Set the desired playback speed using the Pitch
Slider. The actual speed in BPM appears on the
display [14] as well as the difference in percent.
The slider is only active if the [Pitch] key [24] is
on and the Pitch-LED [25] enlights.
[11] LOAD Button
The function of this key depends on the set mode
of the Jog Shuttle Wheel [1] and [2]. In Search
mode (standard), the next title of the Playlist is
loaded into0 the Player by pressing of the [LOAD]
key.
In Cue mode, additional holding of [LOAD] key
will cause a change of current position of Cue-
Point by beat or by tact (see chapter 'Beat
stepping using BPM Studio' too). In Archive mode,
pressing the [LOAD] key will load the selected
title into the Playlist using the Jog Shuttle Wheel.
This title will be loaded into Player immediately
by double click.
Holding the key longer than 3 seconds will replace
the complete Playlist by the selected group or
playlist in the archive.
[12] Track Selector
You can move inside the Playlist using the Track
Selector. A full turn of the ring switches 24 titles
down the list. If you navigate in really big lists,
then by pressing the Track Selector and turning it
at the same time, you can move by 10 steps at a
time. By pressing the button the selected title will
be loaded into the Player.
[14] The VFD display
In the VFD display, all the parameters and activity
modes of the respective Player will be shown as
follows: