ABL electronic USB 2.0 Camera Microphone none User Manual

USB2.0 CAMERA MICROPHONE
User's Guide
Information Before Using Information Before Using
PnP (Plug & Play) is only available in Windows 2000 and XP
versions. Other operation systems (for example Novell and NT) do
not support this function.
To Avoid damage of the image sensor please do not point directly
into the sun light Please keep the camera away from heat to avoid
electronic shocks.
Please keep the camera away from rain or moisture, wipe the
camera lens with moistened soft cloth or neutral solvent.
Please do not disassemble the camera as this will invalidate the
warranty. Misuse or abuse may cause electric shock and again will
invalidate the warranty .
System Requirement System Requirement
•Intel ® Pentium 4 1.4G Hz,AMD Athlon ® prcoessor (2.4G Hz
processor recommended)
•128MB RAM (or minimum OS requirement whichever is higher)
•50MB available hard drive space
•16-bit colour display adaptor (thousands of colours)
•Windows ® compatible sound card (full dupiex sound card
recommended)
•Microsoft ® Windows ® 2000/XP
•CD-ROM Drive
Operating Environment Operating Environment
Temperature: 5 ° C - 40 ° C (41 ° F - 104 ° F)
Relative humidity: 10% R.H. 80% R.H
Illumination: 200 lux or more
Package
Camera unit with USB cable
CD-Rom containing drivers
User's Guide
contact your dealer if anything listed above is missing
Technical Specifications Technical Specifications
Sensor Type 300K CMOS sensor
Resolution 640* 480 pixels(Up to 1280 *1024 pixels)
Interface USB 2.0
Frame Rate 30fps (CIF Mode); 30fps (VGA Mode)
3cm to infinity
Focus
Windows 2000 / XP
OS Platform
Microphone Sensitivity -40db
Zoom 4X
※Audio function does not support on windows 2000
Driver & Camera Installation Driver & Camera Installation
1. Place the CD diskette into your CD-ROM drive (Please do not
connect the camera at this stage).
2. The CD-driver will auto-run and then the installation menu will
come up on your screen (if it does not, please run the program
"Install.exe" from the CD-ROM drive) The menu will show the
installation buttons for the camera driver .
3. Click the button "Install camera driver" to start installation.(Please
refer to Application software Installation)
4. After finishing the installation, please reboot your computer to
restart windows.
5. Plug the camera into an available USB port on your PC or USB
hub. Your computer will detect the new device "PC camera" and
will appear in the windows task bar . (You may need to restart
your computer again once this is completed.)
6. This camera is applicable with microphone function, either via
USB cable or via additional audio cable, if it is audio cable, please
plug it into the MIC-IN of your sound card.
7. In some cases, while detecting new devices, Windows may ask
for your original Windows-CD driver. Please follow the instructions
to insert your Windows-CD and run the program
8. Once you have plugged in your camera, please open AMCAP
which can be found by going into START and then selecting
programs.
Application installation Application installation
Select this to install camera driver
step 1
step 2
step 3
Plug your camera
into USB port
step 4
step 5
step 6
Check Your Device Check Your Device
Please choice your device "Mic Cam 2.0" & "USB Audio",and
Preview must be selected.