American Standard 18" Towel Bar 7010.180 Installation Instructions

GREEN TEA
18"TOWEL BAR
24"TOWEL BAR
GLASS SHELF
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read instructions carefully before you begin.
Recommended Tools
10'
Tape Measure
1
MOUNTING BRACKET INSTALLATION
18" TOWEL BAR, 24" TOWEL BAR AND 24" GLASS SHELF
The 18" TOWEL BAR, 24" TOWEL BAR and GLASS SHELF work best if secured to a wall stud or cross brace within the wall, using 1-1/2"
long SCREWS (3) not supplioed.
If the 18" TOWEL BAR, 24" TOWEL BAR and GLASS SHELF are to be installed on a tile or plaster wall the ANCHORS and SCREWS
should be used.
Determine desired height and location (optional) for the accessory and mark a center line. Use the full size template supplied to mark
hole locations for the mounting brackets. For the 24" TOWEL BAR and GLASS SHELF use 24" template. For 18" TOWEL BAR use 18"
template. If MOUNTING BRACKET (1) is secured to a stud or cross brace drill small pilot holes for SCREWS (3).
For installations on drywall or tiled walls, use ANCHORS (4) and SCREWS (2) for securing MOUNTING BRACKETS (1) to wall. Use MOUNTING
BRACKET (1) as a template and mark the mounting holes. Drill three 1/8" diameter holes a minimum of 1-1/4" deep. Insert the three
ANCHORS (4) flush with face of the finished wall.
Secure MOUNTING PLATES (1) to wall with SCREWS (2).
2
INSTALL 18" TOWEL BAR, AND 24" TOWEL BAR
Place right ESCUTCHEON (5) onto MOUNTING BRACKET (1), and secure
with SET SCREW (6) using 2.5 mm HEX WRENCH (7) supplied.
Place LEFT ESCUTCHEON (5a) onto MOUNTING BRACKET (1a) and
secure with SET SCREW (6) using 2.5 mm HEX WRENCH (7) supplied.
MOUNTING BRACKET
MOUNTING
for GLASS SHELVE
BRACKET
DRILL 3 PILOT HOLES FOR
WOOD SCREWS (2) OR
MOUNTING
ANCHORS 1/8" DIA. HOLES FOR
SCREWS
ANCHORS (4)
(SUPPLIED)
"
1-1/2
1
Installation
Instructions
Level
24" (610mm)
7010.024
GLASS SHELF
18" (457mm)
7010.180
18" TOWEL BAR
CENTER
LINE
TEMPLATE
POSITION OF
MOUNTING BRACKET
FOR TOWEL BARS
CENTER
LINE
DRILL 3 PILOT HOLES FOR
WOOD SCREWS (2) OR
4
1/8" DIA. HOLES FOR
ANCHORS (4)
7010.180
7010.240
7010.024
Certified to comply with ANSI A112.18.1
Drill
7010.240
24" TOWEL BAR
FINISHED WALL
MOUNTING BRACKET
for GLASS SHELVE
Phillips Screwdriver
Regular Screwdriver
18" (457mm)
or
1a
24" (610mm)
5a
6
LEVEL
CENTER LINE
(OPTIONAL TO
FINISHED FLOOR)
2
1
4
FINISHED WALL
M 9 6 8 6 3 1
CENTER
LINE
1
5
6
7
5a
5,
6