The Zone Controller - FHP 641-224 User Manual

The Zone Controller

The Zone control board also known as DDC
and shown in figure 1 is used in most
configure to order applications.
It is BACnet® native which makes it flexible
and easy to integrate into existing Building
Automation Systems (BAS). The main
difference between the 560 and the I/O 583
is the Analog Output (AO) plug enclosed in
figure 1.
Figure 1 - Zone Controller
Analog plug enclosed in red box on figure above is only available on Zone I/O 583.
The controller is programmed in the factory
with software versions that suit the different
applications FHP offers. User settings such
as the time and test and balance set points
shall be set up during the installation and
commissioning process at the job site.
4