Inputs
RS Room temperature sensor (Rnet)
RS Room temperature sensor Set point adjust (Rnet)
RS Room temperature sensor Occupancy override (Rnet)
Discharge air temperature sensor
Leaving water temperature sensor
Unit Protection module (UPM) Alarm codes (7 safety shutdown alarms)
Unit Filter status (optional)
Unit Enable manual control (optional DI Enable)
Outputs
Unit blower control
Reversing Valve
Cooling Stage 1
Cooling Stage 2 (Comp 2 Circuit or Comp1 Stage 2)
Humidity control output (optional Hot gas re-heat)
Auxiliary/Emergency Heating Stage (optional Electric Heat)
Control & Status Parameters and Alarms
Control
BACview occupancy schedule
System control: Schedule, Manual ON, BAS command or DI Enable
Room temperature occupied cooling/heating set point
Room temperature unoccupied cooling/heating set point
Unit blower control
Reversing valve control
Compressor 1 control
Compressor 2 control (Comp 2 Circuit)
Unit Enable manual control (optional)
Humidity Control ( hot gas re-heat optional)
Auxiliary/Emergency Electric heat output control (optional)
11