INSTALLATION INSTRUCTIONS
PZ 60 inch Side Discharge Deck Kit - 966555302
Tools Required
•
½" socket or wrench (battery terminals, strut
shaft).
•
½" breaker bar with 2-3" extension (relieve tension
on idler arms).
Refer to Operators Manual when needed.
PZ Cutting Deck Installation
1.
Disconnect negative cable from battery on the
chassis.
2.
If installing the deck on a diesel unit, remove the
belt from the deck assembly and use the belt
included with the chassis.
3.
Make sure the deck is latched in the transport
position (furthest forward position).
4.
Slide the deck under the chassis.
5.
Block the deck up with boards, pallet, or pallet
jack, so the deck lift chains line up with the
brackets on the deck.
6.
Using the
/
clevis pins* and E-rings*, connect all
7
16
four chains to the deck.
7.
Line up the cast struts on the chassis with the
u- brackets on the deck.
a.
Cast strut
b.
Carriage bolt,
/
5
16
c.
Strut pin
d.
Nut,
/
-18, nyloc
5
16
e.
Clevis pin,
/
"
7
16
f.
E-ring,
/
"
7
16
g.
Lift chain
P/N 575 661201R1
02/22/10
-18 x 1
WARNING!
The deck lift system on the chassis
has springs that assist in lifting
the deck. Leave the deck lift in the
transport position when installing
the deck. Failure to follow these
instructions could result in injury.
8.
Slide the strut pins* through the deck brackets
and cast struts on each side.
9.
Secure the strut pins to the deck on each side
with
/
" carriage bolts * and nuts *.
5
16
10.
Remove the block from under the deck.
11.
Lower the deck to the 3" cutting height.
12.
Remove deck belt shields.
*Supplied in the hardware bag included with the
chassis
b
a
c
d
8058-121
g
f
e