GE Monogram ZIFI240PLII Dimension Manual

ZIFI240PII – GE Monogram Fresh-Food Refrigerator Module
(Custom panel required)
ZIFS240PSS – GE Monogram Fresh-Food Refrigerator Module

(Stainless steel)

Dimensions and Specifications (in inches)

Installation Space

34-1/2"-35"
Depth Including
Handle:
26" Stainless Steel
Models Only
Note: If installing between frameless
cabinets, a 1/2" wide filler strip or side panel
may be required. The filler strip will act as a
spacer between the door case and adjacent cabinet
and will prevent interference with cabinet door swing.
The width of the opening must include filler panels.
The cutout depth must be 24"
The cutout dimensions shown allow for a full door swing and access
to the pull-out racks when installed as a built-in.
• The Fresh-Food Refrigerator can be free-standing.
• The stainless steel model ZIFS240PSS can be installed flush with
standard cabinetry. ZIFI240PII with custom panel will project
forward 1-3/4" of adjacent 24" deep base cabinets.
• Note: Door swing is not reversible.
Additional Specifications:
• A 120 volt 60Hz., 15 or 20 amp power supply is required. An
individual property grounded branch circuit or circuit breaker is
recommended. Install a properly grounded 3-prong electrical
receptacle recessed into the back wall as shown. Electrical
must be located on rear wall as shown. Note: GFI (ground fault
interrupter) is not recommended.
Specification Revised 7/05
120032
Locate Outlet
10-1/2"
24" Min.
9"
Max.
23-3/4" Stainless Steel
Models
1-1/2"
24-7/8" Framed Models
23-3/4" Min.
23-3/4"

Product Clearances

Models with a Custom
Door Panel
24"
Cabinet
110˚
16" Minimum
34-1/2"
All models are factory set for a 110° door swing.
For a minimum 90° door swing:
• Allow 4" min. clearance to wall on the hinge side for Stainless
Steel models.
• Allow 4-1/2" min. clearance to wall on the hinge side for models
with a custom panel and custom handle.
For a full 110° door swing:
• Allow 14" min. clearance to wall on the hinge side for Stainless
Steel models.
• Allow 16" min. clearance to wall on the hinge side for models with
a custom panel and custom handle.
Listed by
Underwriters
Laboratories
R
For answers to your Monogram,
GE appliance questions, visit our website at
®
GEAppliances.com or call GE Answer Center
service, 800.626.2000.
Stainless Steel
Models
24"
Cabinet
110˚
14" Minimum
GE Profile or
® ™
®