Wintal A-1255 Instruction Manual

IR Repeater Kit Instruction Manual
The IR Repeater Kit connects IR Connecting Block, IR Receiver, IR Emitter, and
Power Supply together to interface the IR system to the audio/video components.
Related Components:
In-Wall IR Connecting Block
In-Wall IR Receiver
Dual IR Emitter
Single IR Emitter
Switching Power Supply
 In-Wall IR Connecting Block
FEATURES
1. Three emitter output connections.
2. Convenient IR confirmation LED.
3. Status power receptacle with LED indicator.
4. Power receptacle with LED indicator.
5. Large detachable IR receiver connection.
6. Mounting near audio equipment.
SPECIFICATIONS
Dimensions: 70W x114H x 40Dmm
Weight : 56g
INSTRUCTIONS
Power
Connect a 12 VDC (200mA to 1A) power supply to the power jack of the IR Connecting Block. The
red LED will be illuminated when powered. This will power all of the IR components connected to
the system. Depending on the type of components and the number of components will determine
how much current the power supply will need to provide.
Status Power
12VDC 200mA 2.1mm + Tip – sleeve.
Connect a power supply to this connection will power the status connection. The green LED will
be illuminated. This can be from a 12 volt trigger output or from a wall type power supply plugged
into a switched outlet of a stereo receiver. If you are using products like the In-Wall IR Receiver
that have a status indicator, simply plug a 12 VDC power supply into the switched outlet and when
the receiver is turned on the status LED will be illuminated.
In-Wall IR Receiver Connection
Connect the In-Wall IR Receiver to the detachable connector labeled +12VDC, GND,
STATUS, and SIGNAL.
Emitter Outputs
Connect up to 3 emitters to the emitter jacks labeled 1-3. Place the emitters on the source
equipment.