Download Print this page

Audioplex IR STATION Installation Manual

Chassis / in-wall termination and trouble-shooting point for ir repeating systems

Advertisement

Quick Links

Connectors:
Emitter outputs:
Power supply:
Dimensions:
Test Jack:
The IRStation provides a convenient connecting point and trouble shooting station for a remote relay system, eliminating
hard-wiring. Each room has it's own screw-down connector for the IRTarget (depluggable screw-down connectors for in-wall
versions), each emitter and the power supplies have their own plug-in jacks. Every IRBug(Stick-emit) or IRFlood(TBW) has
it's own visible LED which flashes to verify operation.
The IRStation includes a jack for an optional 12vdc wall adaptor. By plugging the adaptor into your receiver's switched AC
outlet, you will provide SYS-TAT power whenever the receiver is turned on.
NOTE: must ground yellow wire(S1) from IRTarget for proper operation.
IN-WALL VERSION
Back connections
DEPLUGGABLE
CONNECTOR
BLUE
T
PURPLE
S
BLACK
G
RED
V
T
S
G
V
T
S
G
V
IMPORTANT! Refer to IRTarget sheet for detailed wiring diagram
Your AUDIOPLEX TECHNOLOGY(tm) IRStation(tm) is covered by a lifetime warranty against any defects in workmanship and
materials. Any defects will be remedied without charge for labor or parts.
Damage incurred by shipping or by accident is not considered to be a defect, and not covered by this warranty. AUDIOPLEX
TECHNOLOGY(tm) is not responsible for defective operation caused by abuse or by modification or service by any unauthorized person or
agency.
The unit must be properly installed and operated according to instructions for the warranty to apply. Any necessary servicing must be
done by AUDIOPLEX TECHNOLOGY(tm). The unit must be shipped with the proof of purchase and in the original carton and packing materials
to avoid damage.
404 GWH P.O. BOX 440
INSTALLATION MANUAL
TECHNOLOGY
Termination and trouble-shooting point for IR repeating systems
TO BE USED WITH AUDIOPLEX BRAND IR ONLY!

SPECIFICATIONS

Screw-type (depluggable connectors for in-wall versions)
1/8" mini-jack
+12vdc power supply (unregulated, included)
Chassis version: 6.75"H x 1.625"W x 1"D
Allows testing of IRTargets and Emitters (1/8" IRTarget Tester optional).
TEST
12 vdc power supply
WARRANTY
MELVIN VILLAGE, N.H. 03850
E-MAIL: audiolex@conknet.com
IR STATION
TM
CHASSIS / IN-WALL
Back connections
DEPLUGGABLE
CONNECTOR
SYS-TAT(optional)
T
SIGNAL
S
GROUND
G
12 VDC
V
T
S
G
V
T
S
G
V
12 vdc system status(optional)
1/8" test input connector
CHASSIS VERSION
EMITTERS
SYS-TAT(opt.l)
BLUE
T
SIGNAL
PURPLE
S
GROUND
BLACK
G
12 vdc
RED
V
T
S
G
V
T
S
G
V
T
S
G
V
T
S
STATUS(T)
G
V
T
TEST
S
G
V
POWER(V)
603-544-8601
FAX: 603-544-8901
REV.B
1
2
3
4
5
6
12 vdc system status
(optional)
1/8" test input connector
12 vdc power supply
2002 - 8/23/02

Advertisement

loading

This manual is also suitable for:

Irstation