Audioplex SHELFTOP IR TARGET Installation Manual

INSTALL ATION MANUAL
Connector:
Remotes:
Range:
Acceptance angle:
Wire:
Power:
NOTE: The following must be specified when ordering: 1. Niles or Xantech compatible 2. 40 KHz or 56 Khz.
Your ShelfTop IRTarget is designed to act as a remote receiver and processor of infrared
signals. This sensor will receive signals from remote controllers and send these signals to a
remote repeater. This allows remote operation of any unit from the room where the ShelfTop
IRTarget is located.
CAUTION: Take care to make sure that the ShelfTop IRTarget installation is NOT IN THE
LINE OF SIGHT OR REFLECTION with the repeater. If radiation from the repeater is picked up
by this sensor, a feedback situation is created which will result in instability and unreliable
operation. Undesirable reflection can occur off of light colored walls, windows, mirrors, and even
shiny wood finishes! Also note that the wiring of the unit varies, depending on the type of infrared
equipment that is being used (see back of this page for wiring diagrams). Please call if you have
any questions about your installation.
Any standard type of wire can be used. Shielded or coaxial cable is not usually required
unless the wire passes through some unusually high electrical interference regions.
Prepare the wire leads to and from the Shelftop IRTarget by stripping about 1/4" of
insulation from each of the ends. Twist strands tightly together so that none stick out to cause a
possible short circuit. OBSERVE POLARITY! The sensor will not function if the wires are not in
Your AUDIOPLEX TECHNOLOGY ShelfTop IRTarget is covered by a Lifetime warranty
against defects in workmanship and materials. Any defects will be remedied without charge for
labor or parts.
Damage incurred by shipping or accident is not considered to be a defect, and not covered
by this warranty. AUDIOPLEX TECHNOLOGY is not responsible for defective operation caused
by abuse or by modification or service by an unauthorized person or agency.
The unit must be properly installed and operated according to instructions for the
warranty to apply. Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The
products must be returned expences prepaid, with written authorization from the company. The
unit must be shipped with the proof of purchase and in the original carton and packing material
to avoid damage.
TECHNOLOGY
SHELFTOP IR TARGET
Used as a remote receiver and processor
SPECIFICATIONS:
Screw type.
Will handle almost all standard remote controllers (Note: does NOT work
with B & O equipment, which requires a proprietary confirmation talk-back
function).
110 feet indoors, 15 to 20 feet in direct sunlight.
+ or - 55 degrees off center.
Uses conventional unshielded "zip" or telephone wire.
12 VDC @ 500 mA (unregulated, included with package)
INSTALLATION:
WARRANTY
TM
(Patent Pending)
REV B.
2002 - 8/23/02