Red Hawk PowerSense BL-6000 Series Specification

Modular Multiport InLine Power Hub
Safely and efficiently provide
power over LAN Data cabling
for VoIP phones, Wireless
Networking access points
and other remote access
devices .
The PowerSense In-Line Power Hub from
TM
Red Hawk provides a safe and efficient way
to provide power to VoIP Phones, Wireless
LAN Access Points, Web Cameras and
other LAN Devices without the use of an
external power supply for each device.
Power is supplied over the existing LAN
data cabling system. This greatly improves
the range of installation locations for such
devices, no longer requiring them to be
located near a power outlet. It also adds an
unprecedented level of safety and reliability
for powered LAN devices.
The PowerSense TM Hub is a 24 port
rack-mount chassis powering up to 24
devices. Each 8 port module is
Hot-swappable so that modules may be
added to the chassis without powering
down the unit. If an individual power port is
damaged due to a lightning strike or power
surge, the module bank may be hot
swapped out without powering down the
chassis or disconnecting the other devices
attached to the other power ports in the
chassis.
Layer 3 Switch
Wireless
Access
Point
Example
using existing
Ethernet
Switch
*
Supports the IEEE 802.2af standard for many manufacturers VoIP phones, Access Points, IP Cameras, etc.
BL-6000 PowerSense
Rackmount Chassis
Complete w/24 Ports
When used with an uninterruptible power
supply, the PowerSense
non-stop power for up to 24 connected
devices. Continuous operation of powered
LAN devices is assured, while costly
downtime is avoided. The PowerSense
Hub also eliminates the need for costly
uninterruptible power supplies to be
installed for each powered LAN device,
saving time and extra expense.
The PowerSense
TM
provide maximum value in VoIP network
applications. External power supplies
normally required for VoIP phones become
unnecessary. Power is now supplied by the
PowerSense Hub System to the phones
TM
directly over the existing LAN cabling
infrastructure. A device detection circuit
provides invaluable protection from
over-voltage damage if an incorrect device,
such as a laptop computer, is accidentally
attached to a powered network port.
PowerSense™ operates on Category 5, 5e
or 6 grade LAN Data Cable at standard
Ethernet distances. The BL-6000 series
supports powered devices requiring the
IEEE 802.3af Power over Ethernet Protocol.
PowerSense BL-6000
MidSpan Hub
Wireless
Access
IP Camera
Point
VoIP Phone
Powered Devices
IEEE802.3af Compatible
Wireless Laptop/
Laptop w/Wireless
Tel: 408.945.1800 Fax: 408.945.1396
8 Port Module for
the 24 port chassis
TM
Hub provides
TM
Hub is tailored to
Features/Benefits:
n
n
n
n
n
n
PDA
USA: 1.800.989.4295
24 Port
TM
Power / Data Out
Data In
BL-6500 Module
Hot swappable 8-port modules in the 19"
rackmount ready chassis support IEEE
802.3af powered devices
Each module is current limited for short
circuit protection with power isolation of
1500 VRMS
Each module auto-detects the power
requirement for safety and offers
transparent 10/100Mb and management
operations
Each module has TWO diagnostic LED's –
as shown above
Support for all compliant IEEE 802.3af
powered devices
Each module supplies full 15.4 watts for up
to 8 devices as per the IEEE 802.3af
standard
www.red-hawk.com
Detect (blue)
Power (green)