Preparing For Use; Directions For Use - Koolatron TotalChef Juicin' KMJ-01 Owner's Manual & Recipe Manual

Table of Contents

Advertisement

PREPARING FOR USE

1. Place the juice collector into the appliance. Make sure the
rim is flush with the motor unit.
2. Place the pulp container into the appliance by tilting it
forwards slightly. Insert the top end first and then push
down the bottom end.
NOTE: While you are preparing juice, you can empty the
pulp container by switching the appliance off and carefully
removing the pulp container. Reassemble the empty pulp
container before you continue juicing.
3. Put the filter in the juice collector. Make sure the filter is
fitted securely onto the driving shaft. The blade should sit
below the rim of the pulp container when in place.
4. Hold the lid over the filter and lower it into position.
5. Snap the two clamps onto the lid to lock it into place. (You
will hear a click).
NOTE: Make sure the clamp is locked into position on both
sides of the lid.
6. Slide the pusher into the feeding tube by aligning the
groove in the pusher with the small protrusion on the
inside of the feeding tube.
•4•

DIRECTIONS FOR USE

Off
Position 1
Position 2
"NO-DRIP" CAP:
The Juice Guru is equipped with a "No-Drip" Cap. When you
do not want juice to come out, simply slide the cap over the
spout to block the opening. Wash after every use.
WARNING: Make sure you remove the cap before juicing to
prevent backflow or damage to the unit.
The Juicer will only function if all parts have been properly assembled and the
lid has been properly locked in place with the clamps.
1. For oversized pieces, wash the fruit and/or vegetables
and cut them into pieces that fit into the feeding tube.
2. Make sure your glass or pitcher sits under the spout to
collect the juice.
3. Put the pieces in the feeding tube and gently press
them towards the rotating filter by means of the pusher.
NOTE: Do not exert too much pressure on the pusher, as
this could affect the quality of the end result and it could
damage the filter.
After you have processed all ingredients and the juice flow has stopped, switch
the appliance off and wait until the filter has stopped rotating.
KNOB:
Off
Position 1 - Standard Speed
(For most fruits & vegetables)
Position 2 - High Speed (For hard skin &
tough foods)
•5•

Advertisement

Table of Contents
loading

Table of Contents