Troubleshooting
Problem
No video image
Verify that the Cat. 5 is connected between the RJ-45 jack on
the back of the camera module enclosure and the RF-45 jack
on the back of the wall plate.
Make sure the provided 15 VDC power supply is plugged
into a wall outlet and the 15 VDC jack on the wall plate.
Check the S-video or composite cables to verify they are properly
connected, ensure video display device is powered and make
sure the display device is set to the correct video source
The IR remote control
Verify fresh batteries are installed and positioned correctly.
does not work
Remove power supply plug from the 15 VDC jack on the wall
plate. Wait a few seconds and reinsert the power supply plug.
Can't see an entire
When large documents, such as blueprints, are being viewed,
drawing/page clearly
the smallest details may not appear perfectly. The resolution
on the video screen.
only allows zoomed in images to be clear. However, in viewing
normal size documents, details should be clear.
5615 Raytown Road • Kansas City, MO 64133 U.S.A.
Tel.: 816-353-4787 • Fax: 816-358-5072
email: flexcam@ken-a-vision.com • www.ken-a-vision.com
Try this
800-171-066
ProfCam by Ken-A-Vision
Ceiling DocCam™ II
Installation & Operation Manual
910-171-066
®