Welbilt Baker's Select ABM2H22 Instruction Manual page 12

Usin l Your Bread Machine
12
13
14
The bread machine has a convenient viewing window so that you may watch the
progress of the bread as it is mixed, kneaded,and baked. Occasionally,some
moisture may form in the window during baking. You may lift the lid to look
inside during mixing and kneading stages. However, DO NOT OPENTHE LID
DURINGTHE BAKINGCYCLE,(approximately the last hour) as this may cause
the bread to collapse.
To remove the bread from the baking pan, use pot holdersor oven mitts and
pull slightly forward on the handle, then up and out. Turn the pan upside down
and shake the bread out onto a wire cooling rack. The baking pan has a non-
stick finish so the bread should come out easily. Do not use metal utensils to
remove bread as they may scratch the non-stick surface. If you have difficulty
removing bread from the baking pan, slide a flat rubber or plastic spatula along
the sides of the pan to loosen the loaf. Turn the pan over and shake the loaf out.
Allow the bread to cool before slicing. See Slicing and Storing Bread, page 13.
If the kneading blade remains in the bottom of the baking pan, fill the baking pan
with hot water to loosen. If the kneading blade remains in the bottom of the
bread, use the end of a plastic spoon or other non-metal utensil to remove. Do
not use a knife or any other sharp metal object as it will scratch the non-stick
coating on the kneading blade.
Warning:
To avoid damaging the bread
machine, do not put any object
on top of the unit.
Note:
Always check to see where the
kneading blade is when removing
a baked loaf of bread. If it remains
stuck in the bread,you may
damageit by cutting into it while
slicing.
Occasionallythe kneading blade
may become stuck in the bread,
There is nothingwrongwith your
bread machine. Simply use a fork
and pry the blade out of the bread.
Important:
' o /
If the temperature in the bread chamber is higher than 122° F,the
DISPLAYWINDOWwill show "E01". If the temperature is lower than 14° F, the
DISPLAYWINDOWwill show "EO0".
- PlaGewarm-waterin pan -
immediately after removing bread
to prevent bladesfrom sticking to
shaft.
Warning:
If "E01" error message appears, do
not make another loaf until the
bread machine cools down. If
"EO0"error messageappears, allow
the machineto warm up above14° E
12