Pioneer CT-1270WR Operating Instructions Manual

STEREO
DOUBLE CASSETTE TAPE DECK
C1 -1270WR
Thank you for buying this Pioneer product,
Please read through these operating instructions so you wilt
know how to operate your model properly, After you have
finished reading the instructions, put them away in a safe
place for future reference,
In some countries or regions, the shape of the power plug and
power outlet may sometimes differ from that shown in the ex-
planatory drawings_ However, the method of connecting and
operating the unit is the same.
WARNI NG:
TO PREVENT FIRE OR SHOCK HAZARD.
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE,
IMPORTANT NOTICE
[For U,S. and Canadian models]
The serial number for this equipment is located on the rear
panel Please write this serial number on your enclosed war-
ranty card and keep in a s_cure ares, This is for your security,,
[For Canadian model]
CAUTION: TOPREVENT ELECTRIC SHOCK DONOT
USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD.
RECEPTACLE OR OTHER OUTLET UNI3i[SS THE BLADES CAN
BE FULLY INSERTED TO PREVENT BLAIYkEEXPOSURE
ATTENTION: Pour PREVENmR LES CHOCS ELEC-
TRIQUES NE PAS UT_UBER CETTE FICHE P OLARISEE AWC
UN PROLONGATEUR UNE PRISE DE COURANT OU UNE
AUTRE SORTIE DE COURANT, SAUF SI LES LAMES PEUVENT
ETRE tNSEREES A FOND SANS EN LA1SSER AUCUNE PARTIE
A DECOUVERT
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch, U_S. Canadian, European, U.K,,, and Australian
models are not provided with this switch.
The line voltage selector switch is on the rear panel, Before
your model is shTpped from the factory, this switch is set to
the power requirements of the destination Check that it is set
properly before plugging the power cord into the AC outlet. If
the voltage is not properly set or if you move to an area where
the voltage requirements differ, adjust the selector switch as
follows
1 Disconnect the power cord,
2_ Use a medium-size screwdriver.
3. Insert the screwdriver into the groove on the voltage selec-
tor, and adjust so that the tip of the arrow points to the
voltage value of your area,
Medium-size screwdriver
"This product is manufactured to comply with the radio in- I
I terference requirements of EEC Directive 76/889/EEC and
[82/4.99/EECo "
PIONEER"