Water Fill - Sears Quiet Comfort 758.144106 Owner's Manual

Water Fill
WARNmNG: To reduce the risk of
shock, always unplug humidifier
before cleaning or servicing,
WARNING: To reduce the risk of fire
or shock hazard, do not pour or spilt
water into control or motor area.
if controls get wet, let them dry com-
pletely and have unit checked by
authorized service personnel before
plugging in.
This humidifier is designed for use with
the water bottle located to the right of the
upper grill. The water bottle holds 1.9 gaF
Ions of water. The humidifier should be
positioned where it will be operating.
To fill the whole house humidifier, grasp
the bottle handle at the top of the bottle
and lift it straight up and away from
humidifier base. Take care not to bump
or damage spring valve assembly on bot-
tom of bottle.
NOTE: If it is desired to use approved
bacteriostat, follow directions correctly.
The bottle of the whole house humidifier
wilt hold 1_9 gallons of water.
The water bottle is designed with an "E-Z-
Fill Side-Cap'. Remove the "E-Z-Fi!I Side-
Cap" on the side of the water bottle by
twisting counterclockwise.
Place the opening of the water bottle
under a water faucet and fill. If desired,
add Sears liquid bacteriostat (stock num-
ber 42=14900) to help control the build up
of bacteria and algae. Do not use solid
water treatments. Solid debris could make
the lower valve leak.
install the "E-Z-Fill Side=Cap" by twisting
clockwise. Hand tighten only.
Check for possible leaks by perform°
ing the following:
1. Grasp bottle handle and hold the bottle
upright over a sink.
2. Press up on valve plunger for about
one second to let out a little water.
3. Release the plunger.
/
/
B_se
Turn Cou_ltercBockwise
/ to Remove "E-Z_FiH
/
i
/
Spring VaUve AssemMy
4. Listen for air bubbles. Look for leaks
around the "E=Z-Fill Side-Cap" and
valve plunger.
5. If you hear air bubbles or see leaks,
retighten the "E-Z-Fill Side-Cap" and
repeat steps 1-4.
Wipe off excess water from the bottle.