Advertisement
/
I "-'_OBLEM
_ .,_hes not dry
Spotting and
filming .........
I
CAUSED
BY
• Water is not hot
• COOL DRY option
selected
• Improper loading
• Rinse agent
dispenser
empty
• Hard water
• Water is not hot
• COOL DRY option
selected
• Not enough or,
poor
quahty
detergent
•
• Old detergent
• No rinse agent
SOLUTION
• Raise water heater thermostat
to 140°F if
necessary.
• Do not select COOL DRY option. Allow
dishes to dry in heated air.
• Load dishes so items drain properly. Avoid
overloading.
• Fill rinse agent dispenser
if empty.
• Fill detergent cups to capacity. Use dishwasher
detergent with highest available phosphorous
content. May be necessary to install a water
softener.
• Raise water heater thermostat
to 140°F.
• Drying without heat may cause some
spotting. Do not select COOL DRY option.
• Use more fresh automatic
dishwasher
detergent.
Use detergent with highest
available phosphorous
content,
especially
if you have hard water.
• Use only fresh, automatic
dishwasher
detergent. Store tightly Closed in a cool, dry
place. Discard old, lumpy or separated
• detergent.
Do not fill detergent
dispenser
until ready to wash.
• Fill rinse agent dispenser.
To ='bmove stubborn
spots and film from
glassware:
.
2.
3.
• . 4.
.
Remove all metal utensils from the
dishwasher.
Do not add detergent.
Select HEAVY WASH cycle.
Start the dishwasher and allow to run for
18 to 20:minutes. The dishwasher
will now
I
be in the mam wash.
I
Then open the door and pour 2 cups
(500 ml)•white vinegar into bottom of
dishwasher.
6. Close the door and allow to complete the
cycle.
If vinegar rinse doesn't work: Repeat as
above, except use 1/4 cup (60 ml) of citric
acid crystals instead of vinegar. (Most
drugstores carry citric acid crystals.)
IB
II
IB
3
15
Advertisement
