Advertisement
PROBLEM
Dishwasher
will not start
Dishwasher
will
not fill with water
J
Unu_uallnoi .so
"
I
Disljwas_er _
CAUSED
BY
• Dishwasher not
receiving
electricity
• Dial not in correct
position for qycle
selected
....
• Turning the Dial
too far
• Turning the Dial
too far
• No watersupply
• Water inlet valve
cl.dgge_l ,
• Imp)roperI_ading
• DiShw;_sh_
not
l o, ! : I
-
• To_ mi.:ch _udsing
• Spilled rinse a.gent
• Dishwasher door
interferes with
surrounding
cabinets
SOLUTION
:
• Check house fuse or circuit breaker.
• Make sure Dial is turned far enough and
cycle button is fully pushed in.
• Be careful You do not turn-the Dial any
farther than necessary. There is a delay
between start-up and water fill so you will
not hear any wash action right away.
• See the solution above.
• Make sure water supply valve under sink is
turned on.
• Water valve supply line may be clogged with
sediment. Clean out ....
•Utensils may not be secure on rack pins,
or something small may have dropped from
the rack. Water is causing utensils to rattle.
•Make sure everything
is securely placed
in dishwasher.
Level dishwasher as described in Installation
Instructions. Don't place dishwasher on carpet.
• Improper detergent. Use automatic
• dishwasher
detergent
only or try a
different brand or less detergenL
• if hand dishwashing deter_;ent is used by
mistake, pour one measunng cup of
...
vegetable
oil in bottom of'tub and run
;
dishwasher
through a complete NORMAL
WASH cycle with recommended
amount of
automatic
dishwashing
detergent.
*To remove suds from tub: Open•dishwasher.
•Let suds evaporate. Add 1 gallon of cold
water to tub. Close and latch dishwasher.
Pump outwater by slowlyturning Dial untila•
drain period is reached. Repeat if necessary.
• Spilled rinse agent can cause foam during
washing. This can lead to overflowing. •Wipe
up ac.cidental spill of rinse agent with a
damp cloth.
• Make sure door does not touch cabinets
when opening or closing: Use levelling legs
to level dishwasher.
14
Advertisement
