Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
VacPan
Automatic Dustpan Inlet
™
MODEL: CI-365
READ INSTRUCTIONS BEFORE INSTALLATION
IMPORTANT NOTES:
1. For maximum clearance under cabinets use 2
/
" X 3
/
" short 90° elbow.
1
1
2
2
2. Check for an air tight seal at VacPan™ and elbow prior to installation.
3. If required, use Teflon tape to make air tight seal but do not use glue.
4. Make certain clearance is available in kick space prior to installation under cabinets.
5. Use central vacuum cover plate or double electrical blank plate for access cover when required.
6. Allow
/
" play in vacuum pipe at location of VacPan™ so that fitting connection can be lifted to install or remove
1
2
VacPan™.
BRASS TERMINAL
CONTACT
SPRING TERMINAL
CONTACT
FIGURE 1
Advertisement
Summary of Contents for NuTone VAC PAN CI-365
- Page 1 INSTALLATION INSTRUCTIONS READ & SAVE THESE INSTRUCTIONS! VacPan Automatic Dustpan Inlet ™ MODEL: CI-365 READ INSTRUCTIONS BEFORE INSTALLATION IMPORTANT NOTES: 1. For maximum clearance under cabinets use 2 " X 3 " short 90° elbow. 2. Check for an air tight seal at VacPan™ and elbow prior to installation. 3.
- Page 2 INSTALLATION OPTION #1 - UNDER CABINET ACCESS TO PIPING FROM BELOW Refer to Figure 2 1. Select a location under cabinet for VacPan™ (6) so that new fittings can be connected to existing pipe. Drill small reference hole under location of VacPan™ to determine position in basement or crawl space. 2.
- Page 3 INSTALLATION OPTION #2 - IN WALLS ALONG BASE BOARDS Refer to Figure 3 (ACCESS TO PIPING FROM BELOW) 1. Locate studs (1) in the wall at the location VacPan™ will be installed. 2. VacPan™ should be located tight to one side in stud space. 3.
- Page 4 INSTALLATION NEW HOME CONSTRUCTION Refer to Figure 5 1. Cut out wall plate (9) between two studs at the location of VacPan™. Cut a 6 3/4" piece of wall plate and refasten to floor temporary rough-in block. (10) This will act as temporary rough-in block that will force all trades to finish around providing a slot in wall for installation of VacPan™.