Page 1
Contents subject to change without prior notice. GENERAL DESCRIPTION Toshiba’s 9.5mm series of 2.5" Hard Disk Drives is comprised of fast, high-capacity drives which feature an ATA-7 and Seria ATA 1.0a/Seria TATA II 1.2 interface embedded controller. Toshiba recommends that these drives be installed by a qualified technician.
Page 2
INSTALLATION INSTRUCTIONS Note: Toshiba’s 2.5” HDDs are primarily used in notebook devices. Installation into a notebook varies depending on the system manufacturer. Toshiba’s 2.5” drives that are installed into a desktop PC require a 3.5” installation kit.
Page 3
Single Segment S1 Power Segment P1 FIGURE 1 – 2.5" HDD JUMPER LOCATIONS FIGURE 2 – MOUNTING HOLE LOCATIONS INTERFACE CONNECTOR Drive Side Connector Molex RSD97799-015 or equivalent for board Right Angle Type: Molex 67492-0221, Recommended 67492-0222 or equivalent Host Side for cable Molex 88750-5318 or equivalent (for Connector...
Page 4
TECHNICAL SUPPORT Should you require technical support, contact your computer distributor. If your dis- tributor is unable to answer your questions, have them call Toshiba Storage Device Division Technical Support, on your behalf. TOSHIBA - STORAGE DEVICE DIVISON TECHNICAL SUPPORT...
This manual is also suitable for:
Mk4034gsxMk1034Mk8034Mk6034Mk1234gsxMk1034gsx...
Show all