Techko S082K Operation Manual

TEMPLATE
MODE S082KA
SCREW HOLE
SCREW HOLE SCREW HOLE
TESTING
ALARM OUTPUT AND PANIC BUTTON TEST
To test the alarm output, press the PANIC button located on
front of the unit. (THIS UNIT IS VERY LOUD, COVER THE
SIREN ON THE FRONT OF THE UNIT BEFORE ACTIVATING).
The unit will immediately sound a piercing alarm siren. To
disarm the unit, enter your security code followed by the
#ON/OFF button. (If you have not entered a security code
the default is 0 and S082K is 5
CHIME TESTING
1.Set the function switch to the CHIME position.
2.Enter the security code followed by the #ON/OFF button,
the ALARM LED will illuminate. If this does not happen
repeat steps 1 and 2.
3.Close the door and then open it again, a pleasant chime will
sound 3 times.
4.To disarm the unit, enter the security code followed by the
#ON/OFF button.
5.As long as the unit is in the ARM mode, the chime will
continue to sound until DISARMED .
ALARM TESTING
1.Set the function switch to the INSTANT or DELAY
position.
2. Enter the security code followed by the #ON/OFF button,
the ARM LED will turn on. If this does not happen, repeat
steps 1 and 2.
3. Close the door and open it again in INSTANT mode, the
alarm sounds immediately. If the alarm is in DELAY mode,
the alarm will emit a low beep tone to alert your to disarm the
unit, if not disarmed, the unit will then sound a piercing alarm.
4.To disarm the unit, enter the security code followed by the
#ON/OFF button.
Note: in both modes, CHIME or ALARM (instant / delay) the unit will continue to
sound until DISARMED . The unit will only sound the ALARM if ARMED in
the ALARM mode. If armed in the CHIME mode the unit will sound only the CHIME.
If function switch is changed after the unit has been activated, this will not alter the
sound being produced.
OPERATION
ALARM MODE
1.Before arming the unit slide the function switch to the
INSTANT/DELAY position.
2.To arm the S082X / S082K, enter the security code
followed by the #ON/OFF button, the ARM LED will
turn on. If this does not happen repeat steps 1 and 2.
3.INSTANT mode.
When an entry is detected. The alarm sounds
immediately. This is used to protect you when you
are at home.
4.DELAY mode.
This mode is used when you are leaving your home.
On your return, an entry alert beep tone will sound
to alert you to disarm the unit. If the unit is not
disarmed within10 seconds of entry, the alarm will
sound a110db (S082KA is 115db) alarm siren.
5.The 110db/115db alarm will sound for about 30/36
seconds, while the alarm is sounding or during the
entry alert time the security code can be entered to
disarm the unit.
6.To disarm the unit, enter the security code followed by
the #ON/OFF button.
C H I M E M O D E
1 . B e f o r e a c t i v a t i n g t h e c h i m e , s l i d e t h e f u n c t i o n s w i t c h
t o t h e C H I M E p o s i t i o n .
2 . E n t e r t h e s e c u r i t y c o d e f o l l o w e d b y t h e # O N / O F F b u t t o n .
3 . T h e A R M L E D w i l l i l l u m i n a t e t o v e r i f y t h e u n i t i s O N ,
f o l l o w e d b y a s h o r t b e e p . I f t h e A R M l i g h t d o e s n o t
i l l u m i n a t e t h i s i n d i c a t e d t h e u n i t i s O F F.
4 . T h e c h i m e w i l l s o u n d i f t h e r e i s a n e n t r y. T h e c h i m e w i l l
s o u n d f o r e a c h e n t r y u n t i l t h e u n i t i s t u r n e d O F F ( d i s a r m e d )
N O T E : T h e p o s i t i o n o f t h e f u n c t i o n s w i t c h d o e s n o t
n e c e s s a r i l y i n d i c a t e t h e m o d e t h e u n i t i s i n
( C H I M E / I N S TA N T / D E L AY ) . E a c h t i m e b e f o r e
a c t i v a t i n g t h e u n i t , s e t t h e f u n c t i o n s w i t c h t o t h e c o r r e c t
p o s i t i o n f o r t h e m o d e d e s i r e d .
PANIC ALARM
The red PANIC button on the front panel activates the
alarm during a possible emergency.
1.Press the panic button. This will activate the 110db
(S082KA is 115db) alarm siren.
2.Disarm the PANIC alarm, follow the same procedure as
you would to DISARM the unit.
CAUTION
THE MAGNET GUARD IS EXTREMELY LOUD. FOR YOUR
SAFETY. NEVER PLACE THE UNIT CLOSE TO YOUR EARS.
TO TEST THE ALARM, DIRECT THE UNIT AWAY FROM YOU
AT ARMS LENGTH AND ACTIVATE.
PATENT PENDING NOTICE
THIS PRODUCT IS PROTECTED UNDER FEDERAL PATENT. TRADEMARK AND COPYRIGHT
LAWS AND LAWS PREVENTING UNFAIR COMPETITION. NO DUPLICATION OR SIMULATION OF
THIS PRODUCT IS PERMITTED EXCEPT BY WRITTEN AUTHORIZATION OF TECHKO, INC.
TECHKO AND THE CONFIGURATION OF THIS PRODUCT ARE TRADEMARKS OF TECHKO, INC.
COPYRIGHT 1992 TECHKO, INC. ALL RIGHTS RESERVED
Customer Service :
1-888-8TECHKO (1-888-883-2456)
Website: www.techkomaid.com
Mfg. By
9767 Research Drive
Irvine, CA 92618-4626
MADE IN CHINA
SAFETY SECURITY
MAGNET GUARD
MODEL S082X/S082K
S082KA
1
2 3
4 5
* #
PANIC
S082K
S082X
1 2 3
4 5 6
7 8 9
* 0 #
S082X
OPERATION MANUL