Filter Assembly; Vac Assembly - Sears Craftsman 113.170260 Owner's Manual

Filter Assembly
1. Carefully slide the filter over the filter
cage, sliding it over the center ring cov-
ering the 3 slots until the filter stops
against the lid.
2. Place the hole in the filter plate over
threaded screw of the filter cage.
3. Gently push on the filter plate to seat
the rubber ring of the filter inside the cir-
cular channel of the filter plate.
4. Place filter nut onto threaded screw and
tighten it down. Finger tighten only.
NOTE: Lever of filter nut should be away
from plate as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the filter plate, filter
cage or the filter.
NOTE: Your filter has a red stripe that
matches an in-store displayer. When you
visit your local Sears store, just remember
the color of your stripe for the correct size
filter.
Vac Assembly
1. Locate the lid assembly and the drum/
caddy assemblies (assembled earlier).
2. Position the lid assembly with the inlet
of the unit located in line with the drain
cap and the drum label on the vac.
Allow the assembly to rest on the vac
drum.
3. Rotate both latches down until you hear
the latches snap over the lip of the
drum.
NOTE: For best appearance of the unit,
the inlet of the vac should be located
above the drain.
Lid
Red
Stripe
Cage
Latch
Latch
Inlet
Drum
-Drain