Advertisement
Quick Links
R R
PORTABLE CD PLAYER
CX-CD1234
RAND
(4)LCD screen shows "Er" if the unit can not
The CD mechanism and the sensitive circuitry may cause interference
read CD track data.
to a radio tuner nearby. Do not operate this unit while operating other
radio devices.
Danger
This product utilizes invisible laser
(5)When CD track data has been read.
radiation. Avoid direct exposure to
Unit will start play from track No.1
the beam.
automatically.
Caution
Use of controls, adjustments or procedures not listed in
this manual may result in hazardous radiation exposure.
C O M PAC T
Only compact discs identified with this mark can
Press
STOP(
)button to stop play,
be used with this player.
DIGITAL AUDIO
and the last track number will display.
Press
PLAY/PAUSE(
)button to pause
on/off alternately.
Timer will flash on pause mode.
(1)Press
PLAY/PAUSE
(
)button to turn
Press PLAY/PAUSE button again, then the
on the power.
the unit displays continually and plays the
current track .
(2)LCD shows"
"and then total number of all
the tracks.
(3)LCD shows NO DISC when CD is not in the unit.
1
ALL
INTRO
RND
HOLD
PROG
Charge switch
DC jack
DBBS switch
Headphone jack
Hold switch
Volume control
RANDOM button
Open door lock
PROG button
MODE button
RAND
LCD Display
Play/Pause button
FF
button
REW
button
Stop button
(1) Press MODE button once
to repeat one track.
(2) Press MODE button twice to repeat
(1) Press
FF
(or
REW
)button to select the
all tracks.
desired track# . Press
PLAY/PAUSE
INTRO PLAY
button to play. Press
FF
(or
REW
)
Press FF button
To listen to the first 10 seconds of each track.
button to change the track # during the play
(1) Press MODE button three times and
mode.
INTRO will flash.
(2) Press PLAY button to start INTRO from track
No.1.
(2) During play, press
REW
button to play
(1) Press RAND button to play tracks in
previous track.
Press REW button at the head of NO.4
random order. RND will flash.
(2) Press
PLAY/PAUSE
(
) button to play
tracks in random order.
(3) Press FF
button to play tracks in random order.
(3) In pause mode, press
FF
(or
REW
)
(4) During RANDOM mode, press MODE button one
button to play the next track (or previous track).
time can repeat one track. RND and
1
The unit will keep in pause mode.
flash.
(4) During RANDOM mode, press MODE button two
times can repeat all tracks. RND and
ALL
During play, press and hold
FF
(or
flash.
REW
) button to fast forward (or
(5) To cancel RANDOM mode, press RAND or
fast reverse) to the current track.
3. Unplug the AC adapter after charging.
BATTERY OPERATION (BATTERIES NOT INCLUDED)
DO NOT CHARGE THE BATTERIES MORE THAN 24 HOURS
Your unit operates on two(2)AA size alkaline batteries. Open the
OR MORE THAN RECOMMENDED TIME. OVERCHARGING
battery compartment cover and insert the batteries in the battery
MAY DETERIORATE THE PERFORMANCE OF THE
compartment following the polarity diagram located inside.
RECHARGEABLE BATTERIES.
RE-CHARGEABLE BATTERY OPERATION
(BATTERIES NOT INCLUDED)
4.If the operating time decreases drastically after the batteries
have been recharged properly, purchase new rechargeable NiCd
You can operate this unit with two "AA" rechargeable batteries.
batteries.
For new or exhausted rechargeable batteries, we recommend that
batteries are recharged for 15 hours before use.
Do not attempt to recharge alkaline batteries . This may cause leakage
and damage to the unit.
(Refer to battery manufacturer's guide)
Do not mix alkaline batteries with rechargeable batteries.
When operating the unit with AC adapter and non-rechargeable
Do not leave the batteries on recharge for long periods of time. This can
batteries in the compartment, please make sure to set the
damage the performance of the cells.
"charge" switch to "off" position to avoid damaging the unit.
1.Open the battery compartment cover and insert the rechargeable
Due to the nature of CD technology, the unit uses power even when the
batteries (2 x "AA" )in the battery compartment following the polarity
unit is off. To extend the batteries' life, use the adapter for indoor opera-
diagram located inside
tion or where power is supplied. Use the battery operation only when the
BOTH BATTERIES MUST BE RECHARGEABLE NiCd TYPES OR THE
unit is in mobile.
BATTERIES MAY EXPLODE OR LEAK.
2.Plug in AC adapter and slide the "CHARGE SWITCH" to "ON"
This HOLD function prevents any unwanted function changes during PLAY
position to start charging
or STOP mode. Slide HOLD switch to the arrow direction (or opposite) to
USE ONLY THE AC ADAPTER SUPPLIED WITH THE UNIT FOR
turn the function ON (OFF). No other function buttons operate on HOLD
CHARGING.
mode, except DBBS function button.
1
(1) TO PROGRAM
(1)
is displayed when the battery voltage
(a)Press
PGM
button at stop mode and
ALL
PROG
reaches low.
"PROG" will display and flash.
(2) When the voltage is too low, the unit will
(b) Press
FF
(or
REW
) button to select
automatically turn off.
INTRO
the track number.
PROG
(c) When desired track is displayed, press
PGM.
button to set.
(d) Repeat (b)~(c)to set up 20 tracks.
RND
The display will show the current set track.
(e) Tracks set can be checked by pressing
General
RND
PROG.
button.
Maximum Output (Stereo Headphone..15mW+15mW(32ohm)
Single Output........................................0.6V, 47kohm
(2)
TO COMPLETE THE PROGRAMMING
1
RND
AND TO PLAY
will
Press
PLAY/PAUSE
(
)button to start the
AC Adapter......................................120V 60Hz(not included in CX-CD116)
ALL
programmed tracks.
RND
will
DC....................................................4.5V with DC Adapter
(3) TO CLEAR THE PROGRAMMING
STOP
( )button.
Press
STOP
(
)button.
The Dynamic Bass Boost System(DBBS) enhances the low frequency(Bass)
response of the output. Set the Volume to low listening level and press DBBS
switch in the direction of the arrow to turn this function ON.
Note: Some CD's with DBBS may exceed the bass response capacity and
can cause distortion. To avoid this, do not play DBBS in high volume.
Playing DBBS in high volume may cause damage to the headphone and
more importantly, to your hearing.
Hearing experts advise against the constant use of personal stereos played
at high volume. Constant high volume use can lead to hearing loss. If you
experience ringing in the ears or hearing loss, discontinue use and seek
medical advice.
To remove the disc from its storage case, press down on the center of
.
the case and lift the disc out. Hold it carefully by the edges as shown
below.
Insert the disc into the unit with the label of the disc facing up.
Gently wipe the disc using a soft cloth from the center to the outer
A M / F M R A D I O R E C E I V E R
BATTERY OPERATION
1. Apply thumb pressure to battery cover and slide it down.
2. Use 2 "AAA" size batteries (UM-4) only, insert batteries with correct polarity.
3. Close battery cover.
**Remove the batteries when they are exhausted or when the unit is not
going to be used for a long time.**
RADIO OPERATION
1.Rotate Volume Knob clockwise to turn radio on to a desired sound level.
2.Slide Band Switch to desired band.
3.Rotate the Tuning knob to desired station.
4.For FM reception please extend the earphone as this acts as the FM antenna.
5.Rotate the unit direction for maximum reception of AM band.
6.Replace old batteries or remove the batteries when the unit is not going to be
used for a long time.
MAINTENANCE
1. Do not expose the unit to rain, moisture, or extreme temperature.
2. Do not place the unit near strong magnets.
3. Do not use benzene thinner or any abrasive powder to clean the cabinet,
wipe it with a soft cloth moistened with a mild soap and water solution.
FCC STATEMENT
This device complies with part 15 of the FCC rules. Operation is subject
to the condition that this device does not cause harmful interference.
TECHNICAL SPECIFICATION
FM 88-108 MHz
Frequency Range:
AM 530-1700 KHz
3V with 2 size "AA" Batteries(not included)
FM
10.7 MHz
IF Frequency :
AM
455 KHz
Power Source :
DC
3V
direction to remove dust, fingerprints or any other particles on the
disc surface. Never use chemicals, such as record sprays , anti-static
sprays, benzene or thinners to clean the CD. These chemicals can
damage the disc surface permanently.
To avoid serious scratches on CD, keep them in the cases after each
use. Scratches can cause the laser pick-up skip in the future play.
Do not place stickers or write anything on the disc.
Read the instruction manual before operating this unit.
Do not expose the unit to high temperature or humidity.
Use dampened soft cloth to clean the unit. Do not use strong
detergent or solvent to clean the unit.
Ensure that all electrical connections (including the main plug,
extension leads and interconnections between pieces of equipment)
are properly made and in accordance with the manufacture's
instructions.
Consult your dealer if you are ever in doubt about the installation,
operation or safety of your equipment
PROP . 65 WARNING:
Handling the coated electrical wires of this product exposes you to
lead, a chemical known to the State of California to cause cancer,
birth defects and other reproductive harm.
Wash hands after use.
Advertisement
