Advertisement
Quick Links
This manual describes how to install and use the Second Solar Panel for the
EZ-Solar Power Kit. The second panel is for use in far northern or southern lat-
itudes, where wintertime light is limited, as well as other locations with lim-
ited solar exposure. This panel doubles the amount of light-gathering
capability of your solar powered EZ-Mount system. It includes a solar panel
and regulator circuit.
Note: The Second Solar Panel is only for use with the EZ-Solar Power Kit 7707.
CAUTION:Please note that while we have made every attempt to design and manufacture a safe product,
Davis Instruments cannot assume liability for any injury or damage caused directly or indirectly by the
installation or use of this product.
Components
The EZ-Solar Power Kit includes the following components. Please be sure
you have all listed components before beginning.
5/16"
Hex Nut
Cap
Cable Ties
S
E C O N D
F
E Z -S
O R
Brace Clamp
5/16" x 2"
Carriage Bolt
Y-Terminal
Adapters
S
O L A R
P
O L A R
O W E R
Power
Connectors
P
A N E L
K
I T
Solar Panel
Shelter
Arm
Power
Cable
Product # 7705
Advertisement
Summary of Contents for DAVIS EZ-Mount Solar Power Kit
- Page 1 Note: The Second Solar Panel is only for use with the EZ-Solar Power Kit 7707. CAUTION:Please note that while we have made every attempt to design and manufacture a safe product, Davis Instruments cannot assume liability for any injury or damage caused directly or indirectly by the installation or use of this product.
-
Page 2: Installation Guidelines
Tools and Materials Needed Tools and Materials Needed You may need the following for this installation: ✦ Adjustable Wrench or 5/16” Wrench ✦ Flat Head Screwdriver ✦ Pliers ✦ Wire Cutters or Scissors Installation Guidelines ✦ The power cable supplied is six feet (6’, 1,8 m) long. Mount the Second Panel close enough to your EZ-Solar Power shelter for the power cable to reach without stressing the power cable connections. - Page 3 Connecting the Cables 10. Connect the red and white wires from the Second Solar Panel to the Y-ter- minal adapter on the postive (+) battery terminal. 11. Connect the black wires from the Second Solar Panel to the Y-terminal adapter on the negative (-) battery terminal. Second Panel power cable connections to the Y-terminal adapters 12.
- Page 4 Rev. A Manual (3/30/2001) This product complies with the essential protection requirements of the EC EMC Directive 89/336/EC. © Davis Instruments Corp. 2001. All rights reserved. 3465 Diablo Avenue, Hayward, CA 94545-2778 510-732-9229 • Fax: 510-732-9188 E-mail: info@davisnet.com • www.davisnet.com...