Table of Contents
Advertisement
Operating Instructions
Problem
Water runs out from
under the washing ma-
chine.
Fabric softener was not
washed in, compart-
ment æ for condition-
ers is filled with water.
Washing heavily
creased
The washing has not
been spun as dry as
usual.
The washing is not suf-
ficiently spun. Water is
left in the drum.
The fault code
appears . The RINSE
display flashes.
34
Possible Cause
The screw connection on the
inlet hose is leaking.
The drainage hose is leaking.
The washing drain pump
cover is not correctly closed.
Washing is caught in the
door.
The emergency emptying
hose is not correctly closed
or is leaking.
The conditioner insert in the
compartment for the condi-
tioners is not correctly at-
tached or is blocked.
Probably too much washing
put in the drum.
The washing was not able to
be distributed evenly in the
drum prior to spinning.
Drain hose is kinked.
Maximum pump head (dis-
charge height 1m from the
appliance's base) is exceeded.
E20
Drain pump is blocked.
Remedy
Tighten the inlet hose screw
connection
Check the drainage hose and
replace it if necessary.
Close cover correctly.
Stop the programme and re-
move the washing caught in
the door. Restart the
programme.
Close the emergency empty-
ing hose correctly (see the
section "Carrying out Emer-
gency Emptying"). Call your
local Service Force Centre if
the emergency emptying
hose leaks.
Clean the detergent dis-
penser drawer and attach the
conditioner insert securely.
Pay attention to the maxi-
mum load quantity (see Pro-
gramme tables). In the case
of easy-care fabrics, select
the EASY IRON programme.
Always load the drum as ful
as possible with a combina-
tion of large and small items.
Remove the kink.
Contact your local Service
Force Centre. For pumping
heights over 1m a conver-
sion kit is available as a spe-
cial accessory.
Switch off the appliance and
pull out the mains plug.
Clean the drain pump.
Hide quick links:
Advertisement
Table of Contents
