Table of Contents
Advertisement
Water inlet (cold water connection only)
Before connect-
ing the hose be
sure to fit the
mesh filter «A»
supplied as per
diagram.
Installation
should comply
with local water
authority and building regulations' requirements.
Set the hose correctly by loosening the ring nut. After positioning the
inlet hose, be sure to tighten the ring nut again to prevent leaks.
Do not connect to a hot water supply.
Water drainage
The appliance drain hose should hook into a standpipe, the hook in the
drain hose is formed using the plastic "U-Piece" supplied. The standpipe
should have an internal diameter of approximately 38 mm (see dia-
gram) thus ensuring there is an air break between the drain hose and
standpipe.
When discharging into a stand-
pipe ensure that the top of the
curve in the hose end is no
more than 90 cm (35.4") and
no less than 60 cm (23.6")
above floor level.
The upright standpipe should have a mini-
mum length of 30 cm (12") from the bottom
of the elbow to the top of the pipe (see dia-
gram). Make sure that it is designed in such a
way that the end of the drain hose cannot be
covered with water.
Longer drain hoses are available in lengths
of 2.7 and 4 metres from your AEG Service
Force Centre.
A
3 pin
38 mm.(1/ ") diameter
standpipe
Installation
1
2
47
Advertisement
Table of Contents
