Sony PCV-RZ10C - Vaio Desktop Computer Replacement Instructions

These easy instructions are intended to guide you through the replacement process.
To avoid electric shock please make sure product is turned off and disconnected from the power
source. Remove jewelry before you begin work to avoid scratching the surface of your desktop
computer.*
Place your desktop computer on a clean, stable and covered surface to avoid damage to the
computer's case.
Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o Hold parts by the edges, away from exposed circuitry when possible.
o Do not walk around excessively as this promotes static build-up.
The appearance of the electronic components shown in the illustrations may be different from the
components shipped. This slight difference does not affect the accuracy of these instructions.
* Sony is not responsible for any loss of data associated with your computer or any damage caused by
incorrect handling of the computer under these procedures. The terms of your Sony Limited Warranty
continue to apply.
Step 1
.
Place your PC on a
solid surface.
CAUTION!
Disconnect the
power cord, failure to do so can
result in unit damage
personal injury.
Locate the release tabs on the
right as shown.
P/N T99860132 Rev. B
PLEASE READ BEFORE YOU START
*
Tabs
Step 2
.
Press and hold the 2 tabs in the rear,
as shown. Slide the panel in the direction of the
arrows and pull out to remove the side panel,
set panel aside. The inside of the unit will be
exposed.
or
PCV-RZ Series Hard Disk Drive
Replacement Instructions
IMPORTANT!
1/2
Step 3
.
Rotate the PC so the
inside is facing to you. Identify
the location of the Hard Drive's
connections.