Bontrager AIR RUSH ROAD Manual

BoNtRAGeR
AirRush Road
Inflator and hand pump
Figure 1. AirRush Road
inflator
For your safety and the enjoyment of this product,
please read these instructions in their entirety before
using your AirRush.
The AirRush can be used as a CO inflator or as a hand
2
pump. It fits presta valves only.
See the Safety instructions and Warnings.
Hand pumping
1. Fully open the presta valve on the inner tube.
2. Fully close the Air Rush valve.
3. Remove the dust cap from the red
side of the head of the AirRush.
4. With one thumb, hold the tire so
that the presta valve protrudes
from the rim (Figure 2). With the
other hand, grasp the head of
the AirRush and ease it onto the
presta valve.
• Once the pump is on the presta
Figure 2. Squeeze the
valve, you can release the tire.
tire to extend the valve
5. Use the pump handle to inflate the
tire. Avoid pinching your hand
(Figure 3).
• Make sure the tire beads are
correctly seated in the rim. Follow
the inflation recommendations on
the side of the tire.
6. Ease the pump off the presta
valve.
7. Replace the dust cap on the
Figure 3. The pump
AirRush.
handle can pinch if held
incorrectly
8. Close the presta valve.
Inflating with Co
2
Only use compatible 12-gram or 16-gram threaded CO
2
cartridges that are in perfect condition. When using
the AirRush with a cartridge, the pump barrel is not
used.
to install a Co cartridge
2
Do not install a cartridge until you are ready to inflate
a tire. After a cartridge is punctured during attach-
ment to the inflator, it might slowly lose air over time.
1. Turn the valve of the AirRush
(Figure 4) completely to the
CLOSE position.
2. Remove the dust cover from the
cartridge threads (the black side
of the pump head, Figure 5).
3. Gently start the threads of a
cartridge into the threads of the
Figure 4. AirRush valve:
AirRush.
Clockwise to close
• After several turns, a "puncture
pin" will open the cartridge, but
additional turns are required
to close the seal between the
cartridge and inflator. Until
the seal is closed, some CO
2
may escape from a punctured
cartridge.
4. After the cartridge threads are
engaged, quickly tighten the
Figure 5. Threads for
CO cartridge into the head until cartridge (NOT for
2
Schraeder valve)
snug.
5. Slide the cartridge grip onto the
cartridge (Figure 6).
• The cartridge grip insulates
your hand; when inflating, the
cartridge will get very cold.
The AirRush is now ready to inflate a
tire with CO .
2
Figure 6. Black rubber
cartridge grip
to inflate a tire with a Co cartridge installed
2
When using the AirRush as an
inflator, always hold the AirRush
in an upright position, with the
threaded neck of the cartridge
pointing up (Figure 7).
To stop the CO flow, turn the valve
2
to CLOSE; DO NOT unthread the
cartridge. Read the Safety instruc-
tions and Warning.
Figure 7. Inflating the
tire with the cartridge in
1. Remove the dust cap from the red
the upright position
side of the head of the AirRush.
2. Fully open the presta valve of the inner tube.
3. With one thumb, hold the tire so that the presta
valve protrudes from the rim (Figure 2). With the
other hand, grasp the head of the AirRush and ease
it onto the presta valve (Figure 7).
• Once the AirRush is on the presta valve, you can
release the tire.
4. Slightly turn the AirRush valve to OPEN. This will
release CO into the tire.
2
• Avoid inflating the tire too rapidly—make sure the
tire beads are correctly seated in the rim. You can
close the AirRush valve to stop inflating while you
check the bead. Follow the inflation recommenda-
tions on the side of the tire.
5. To stop the flow of CO , turn the AirRush valve back
2
to CLOSE.
6. Remove the AirRush from the presta valve.
7. Replace the dust cap on the AirRush.
8. Close the presta valve.
During inflation, the cold will cause the cartridge grip
to shrink. To remove the cartridge grip, warm the
cartridge.
Carrying the AirRush Road
When carrying cartridges in the
included carrier, put the cartridge
grip on the upper cartridge (Figure
1). If the cartridge grip is on the lower
cartridge, it can fall off.
To prevent the AirRush from falling
from its holder, attach the rubber
clamp band. Place it over the AirRush
valve and then onto the strap attach-
Figure 8. Attaching the
ment of the bracket (Figure 8).
AirRush to the frame
bracket
Safety instructions
A CO cartridge contains CO (carbon dioxide) at very
2 2
high pressure. Over-exposure to CO could be fatal. If
2
the cartridge is punctured or caused to leak at a high
rate, the cartridge may explode or become a projectile
(fly through the air), causing severe injury or death.
Follow these steps to prevent puncture, explosion, or
exposure to CO gas:
2
Use and dispose of cartridges properly.
• Never puncture a CO cartridge.
2
• Keep CO cartridges away from heat above 120°F
2
(49°C). A closed car, or even direct sunlight, can
reach a temperature higher than this. Overheating
may rupture the cartridge. Do not incinerate.
• Do not completely unscrew the AirRush head from
the CO cartridge until the cartridge is empty.
2
Removing the AirRush head from a CO2 cartridge
while CO remains may cause the cartridge to
2
become a projectile. Never dispose of a cartridge
that still contains CO .
2
Only use compatible cartridges that are in perfect
condition.
• Never attempt to refill a disposable cartridge.
• In the event of any actual or suspected malfunction
or damage, discontinue use of the AirRush and
dispose of it properly.
• Use only threaded CO cartridges. Attempting to
2
install a non-compatible cartridge could cause the
cartridge to become a projectile.
Avoid contact with CO .
2
• As CO leaves the cartridge, it drops to a very low
2
temperature and could cause frostbite to exposed
skin.
• Do not discharge the inflator towards your face or
body, or other people.
• Do not inhale CO .
2
• Keep cartridges and the AirRush out of the reach of
children.
WARNING
Contents of cartridge under pressure. Sudden
release of pressure can cause severe injury or
death. Always follow the safety instructions.
Bontrager Limited warranty
Bontrager warrants each new Bontrager component
or wheelset against defects in workmanship and
materials:
For five years-
• All Bontrager components and accessories, except
consumables such as tires and inner tubes.
For one year-
• Bontrager consumables such as tires and inner
tubes.
This warranty does not cover-
• Normal wear and tear
• Improper assembly
• Improper follow-up maintenance
• Installation of parts or accessories not originally
intended for or compatible with the Bontrager fork,
components, or wheelsets as sold
• Damage or failure due to accident, misuse, abuse, or
neglect
• Labor charges for part replacement or changeover
This warranty is void in its entirety by any modifica-
tion of the wheelset or components.
This warranty is expressly limited to the repair or
replacement of a defective item and is the sole remedy
of the warranty. This warranty extends from the date of
purchase, applies only to the original owner, and is not
transferable. Bontrager is not responsible for incidental
or consequential damages. Some states do not allow
the exclusion of incidental or consequential damages,
so the above exclusion may not apply to you.
Claims under this warranty must be made through
an authorized Bontrager dealer. Proof of purchase is
required.
This warranty gives the consumer specific legal rights,
and those rights may vary from place to place. This
warranty does not affect the statutory rights of the
consumer.
©2008 Trek Bicycle Corporation, Waterloo, Wisconsin 59534 USA
Bontrager is a registered trademark of Trek Bicycle Corporation
All rights reserved