Advertisement

Slime 40032 Manual

OVERVIEW

Overview

TECH SPECS

IDEAL USES Tires
TIRE INFLATION TIME 8 min*
CFM 0.49 (13.9 LPM)
AIR HOSE LENGTH 2' (0.6m)
POWER CORD LENGTH 10' (3m)
POWER SOURCE 12 volt accessory power outlet
GAUGE Dial gauge
LIGHT LED

* (0-35 PSI, Standard Tire: P195/65 R15)

  • HOT
  • DO NOT HOLD IN HAND WHILE OPERATING
  • PLACE INFLATOR ON A HARD, CLEAN SURFACE.
  1. DO NOT run vehicle while inflator is operating. Engine must be turned OFF.
  2. DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool approximately 25 minutes between uses. Do not leave inflator unattended.
  3. ALWAYS use a pressure gauge to check tire pressure. DO NOT overinflate.
  4. Keep inflator out of reach of children.
  5. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with older 8 amp cigarette lighter receptacles.

INFLATE TIRES

  1. Screw air hose connector onto tire's valve stem.
  2. Plug power cord into 12 volt accessory power outlet.
  3. Press on/off button to turn on inflator. Inflate tire to manufacturer's recommended air pressure.

    * When proper pressure is reached, press on/off button again to turn off inflator. Unplug power cord and remove air hose connector.

information*NOTE: Correct tire pressure can be found in vehicle owner's manual or on driver's side door jamb.

TROUBLESHOOTING

Inflator does not turn on

  1. The fuse, located in the plug adapter, may have blown. Unscrew the tip of the plug adapter, remove fuse and inspect. If necessary, replace fuse with one of the same size and amperage.
  2. Check vehicle's power outlet fuse; it should be a minimum of 15 amps.
  3. Check receptacle and plug terminals for dirt (particularly tobacco). Use a non-conductive probe (not fingers or metal) to dislodge and remove debris.
  4. Push the power plug firmly into the receptacle and twist it back and forth.

Inflator runs but does not inflate

  1. Be sure the air hose connector is tightly screwed onto the valve stem.
  2. Check tire for leaks. Check hose for breaks and leaks at fittings.

Inflator runs slowly

  1. The inflator may have overheated from excessive use. Shut it off and allow it to cool for 25 minutes.
  2. The voltage may be too low. Check the condition of your vehicle's battery.

information NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim allowing air to leak out when trying to inflate. In the event this occurs, it may be necessary to jack up the tire prior to inflation.

Limited Warranty: For the period of one year from date of purchase, manufacturer guarantees that this Product will meet the specifications when used as directed. Manufacturer's sole liability and Customer's sole remedy under any warranty claim is limited to refund of purchase price or new product upon return of unit and proof of purchase.

QUESTIONS OR COMMENTS: Call 888-45-SLIME or visit www.slime.com

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Slime 40032 Manual

Advertisement

Need help?

Need help?

Do you have a question about the 40032 and is the answer not in the manual?

Questions and answers

Table of Contents