Advertisement
Quick Links
Ceramic Coated Plates
USING YOUR STRAIGHTENER
After washing your hair, it's really important to prepare it for styling. If you use lots of heated
styling tools on your hair always use a heat protection spray before you begin styling.
Always dry the excess water from your hair using a towel, and then use a wide tooth comb
to detangle and smooth your hair.
Use your hair dryer until your hair is thoroughly dry. Divide your hair into sections and comb
each section thoroughly. Use the sectioning clips to clip hair out of the way so you can
straighten hair thoroughly.
Use the On/Off switch to switch your straightener on. Your straightener reaches a very hot
temperature really quickly, so be careful not to leave your straightener on surfaces which
could get damaged like carpets.
Clamp a section of the hair between the straightening plates as close to the roots as
possible. Gently slide the straightener down your hair shaft to the ends. For more difficult
sections of hair, you may need to do this again. Repeat on all sections of the hair.
DON'T FORGET – to switch off your straightener and store when you have finished
straightening. If you want to store your straightener in the gift box, always make sure your
straightener has cooled down and never wrap the cable around the product as this can
cause damage.
Try and clean your straightener regularly for best results. Always do this when the
straightener is switched off and has cooled down.
SAFETY INFORMATION
When using your hair straightener, basic safety precautions should always be followed. Please
read these instructions carefully before using the product and keep them in a safe place for future
reference.
01 This straightener is of a professional standard and reaches very high temperatures. Always
take care not to allow the plates to come into contact with the skin.
02 Do not leave the plates in contact with the hair for more than a few seconds. The straightener
reaches very high temperatures, so there is no need to leave the hair between the plates for
longer than a few seconds. This will avoid unnecessary damage to the hair cuticle.
03 Use the appliance for its intended use only.
04 To protect against the risk of electric shock, do not immerse the appliance in water or any
other liquids.
05 It is recommended that this appliance should not be used by children.
06 Check that the voltage on the rating plate of the straightener corresponds with your house
electricity supply which must be AC (alternating current).
07 Always unplug your appliance when it is not in use.
08 Do not leave the straightener switched on whilst unattended.
09 For UK only - Do not take this product into a bathroom or use near a water basin or
any other vessels containing water. For other European countries - For additional
protection, the installation of a residual current device (RCD) having rated residual
operation current not exceeding 30mA is advised in the electrical circuit supplying
the bathroom. Ask your installer for advice.
MODEL22060
CERAMICSTRAIGHTENER
Easy Grip
On/Off Switch
2 YEAR GUARANTEE
It is in your interest to retain the retailer's receipt as proof of purchase. Please quote the
model number if the product develops a fault. This number can be found on the handle of
the product.
All Morphy Richards products are individually tested before leaving the factory. In the
unlikely event of any appliance proving to be faulty within 28 days of purchase it should be
returned to the place of purchase to be replaced.
If a fault develops after 28 days and within 24 months of original purchase, you should
contact the Helpline number quoting the model number of the product, or write to the
address below. You will be asked to return the product (in secure packaging) to the
address below along with a copy of proof of purchase.
The After Sales Division, Morphy Richards Ltd, Talbot Rd, Mexborough, South Yorkshire,
England, S64 8AJ
Helpline (8.30-5.00 Mon-Thurs/8.30-4.00 Fri)
UK 0870 060 2614
For extra tips on styling and details of the rest of the products in the Morphy Richards
range please see our website
Morphy Richards products are intended for household use only. Morphy Richards has a
policy of continuous improvement in product quality and design. The company therefore
reserves the right to change the specification of it's models at any time.
Registered address:
Morphy Richards Ltd, Talbot Rd, Mexborough, South Yorkshire, S64 8AJ
10 After use, do not store until the product has cooled down.
11 Do not place the straightener on surfaces likely to be damaged by the heat.
12 It is normal to find build up of hair products on the straightening plates. For this reason
therefore, you should clean your straightener regularly. Always wait for the plates to cool down
thoroughly before cleaning. Use a damp cloth to remove any build up. If this fails to clean the
plates, try a non abrasive cleaning wipe.
WIRING
This product is fitted with a 13 amp (BS1363) plug. A 13 amp fuse (BS1362) must be used.
Check that the voltage on the rating plate of your appliance corresponds with your house
electricity supply which must be AC (alternating current). If the socket outlets in your home are not
suitable for the plug supplied with this appliance, the plug should be removed and the appropriate
one fitted.
WARNING: The plug removed from the mains lead, if severed, must be destroyed as a
plug with bared flexible cord is hazardous if engaged into a live socket outlet.
MAINS LEAD
As a safety precaution and to prolong the life of your appliance, do not wrap the mains lead
around the appliance as this can cause damage.
•
Republic of Ireland 1800409119
www.morphyrichards.com
Part Number
PC22060M UK rev 1
Advertisement
