Related Manuals for Kodak ESP 5200 - NETWORKING
Summary of Contents for Kodak ESP 5200 - NETWORKING
- Page 1 Networking Setup Guide Networking Setup Guide Networking Setup Guide Networking Setup Guide All-in-One Printers • All-in-One Printers All-in-One Printers • All-in-One Printers...
-
Page 2: Ethernet Connection
Choosing a Connection Type Make sure you completed the steps in the Start Here instructions. Then choose one of the following connection types for your printer, and see the corresponding chapter for instructions. NOTE: • You can change your connection type later. See the chapter Configuring Your Printer in the Extended User Guide. -
Page 3: Using The Lcd Keyboard
If there are more networks than can be shown on the LCD, a (page down) symbol appears in the bottom right of the display. If you don’t see your network in the list, or if you want to change your network, select Rescan for Wireless Networks, then press OK. -
Page 4: Connecting To A Wps Wireless Router
Select WEP or WPA/WPA2 as required for your network's security setup, then press OK. 5. If your network has security enabled, use the LCD keyboard to enter your security string. 6. When the confirmation message appears, press OK. If the printer is successfully connected, the Wi-Fi status light should be on. -
Page 5: Setting Up The Ethernet Connection
1. Connect the Ethernet cable into the Ethernet port on the back of the printer. 2. Connect the other end of the Ethernet cable into an available Ethernet port on your router, switch, or hub. 3. Install the KODAK All-in-One Printer Software on your computer. Follow the on-screen instructions to complete your setup. - Page 6 Eastman Kodak Company Rochester, NY 14650 © Eastman Kodak Company, 2010 Kodak is a trademark of Eastman Kodak Company. Specifications subject to change without notice. P/N 1K5952 1K5982 May 2010 Printed in China...