Download Print this page

unios Athena 180 Quick Start Manual

Bollard light

Advertisement

Quick Links

Wiring
DALI Optional
DA /L
DA /N
N
L
DRIVER
AC
Power Source
LED
Luminaire
Cleaning
Warning: Before cleaning, disconnect from
mains supply and allow luminaire to cool.
1
2
Disposal
Ensure correct disposal of this
product (waste electrical and
electronic equipment).
Edition 01.03.24 | Product design and technical data may be subject to change
unios.com
Page 4/4
Wiring Connections
22mm
Max Ø 2.5mm
Max Ø 11mm
6mm
2
Dimming
This luminaire can not be dimmed.
Specific DALI option available.
Corrosion Protection
It is important to note that care must be taken
during installation or maintenance to ensure that
the surface of the luminaire is not damaged. Any
damage, which is exposed to moisture will result
in corrosion occurring.
Please also note that any chemical applications on
the luminaire or chemical contact via installation will
cause corrosion of the surface of the luminaire and will
void the warranty.
Athena
Base
Athena 180
Athena 360
Codes
ATBL18
ATBL36
2
Class I
220-240 V ~ 50/60Hz
CAUTION – This product must be installed by a qualified installer
Please read instruction manual carefully before installing luminaire
Surge Protection
For comprehensive protection of a luminaire against electrical surges, surge protection shall be installed
on the mains supply where required to protect luminaires and drivers from transient voltage damage.
For warranty information visit unios.com/warranty
Please read these installation instructions carefully before installing this product. This product must be installed and
maintained by a suitably qualified person/s in compliance with the latest applicable regulations and relevant legislation.
Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper
operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a
'working light' during construction. This will result in the warranty of the product to be void. For warranty duration,
please refer to the data sheet.
A
Edition 01.03.24 | Product design and technical data may be subject to change
IP Rating
Material
Install Person/s
66
Aluminium
1x
Sizing Variations
Product Code
ATBLXX02
ATBLXX06
ATBLXX10
Parts
B
1x T25
Torx Key
6x 25mm T25
Torx Screws
unios.com
Page 1/4
BOLLARD LIGHT
Power
12 | 24 Watts
A
B
Ø 180
250
Ø 180
600
Ø 180
1000
All measurements are in millimetres.
1x IP68 Cable
3x 18mm T25
Connector
Torx Screws
Not included
Not included
OR
Concrete Anchor
3x Dynabolt
ATBL01
(10x100mm)

Advertisement

loading

Summary of Contents for unios Athena 180

  • Page 1 Cleaning Corrosion Protection Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a 'working light' during construction. This will result in the warranty of the product to be void. For warranty duration,...
  • Page 2 Page 2/4 Page 3/4 Measurements Bollard Installation All measurements are in millimetres. Mounting Plate Concrete Anchor 3x Dynobolt 120° 120° ATBL01 (10x100mm) 30° 30° Ø 125 BEAM BEAM Ø 100 Ø 125 Not included Not included Option 1: Concrete Mounting Installation Concrete Anchor (ATBL01) additional accessory required BEAM 120°...

This manual is also suitable for:

Athena 360Atbl18Atbl36