SET UP INSTRUCTIONS FOR 4421F1 - 4424F1
1) Set your fountain on your chosen location and position it
toward your preferred viewing direction.
2) Place the pump and light in the fountain floor. The pump
should be behind the divider wall and the
light should be out in front, aiming back
at the middle of the high fountain wall.
3) Push both power cords out the floor's
corner hole. Open the slit rubber stopper
and place each cord inside one of the slit-
holes. (The hole for the pump cord
should be a little wider than the hole for
the light cord.) Then push the stopper
firmly into place to create a watertight
fountain.
4) Thread the larger adapter into the
coupling low, under the wall as shown
and push the smaller adapter firmly into
the pump.
5) Push the tubing onto the two adapters.
6) Use the provided silicone sealant to apply
the copper spill plate atop the front of the
wall. The sealant should be placed under
and on the outsides of the spill plate.
The plate should overhang somewhat for
a good waterfall. (You may want to
make sure the two guide holes in the spill
plate are plugged with silicone to prevent
any unwanted dripping.)
7) Place the black foam piece in the water channel behind the
copper spill plate to smooth the water flow.
Make sure to place your fountain on a firm
area which will not settle. Note: Always
follow local electrical codes and use a
110V GFCI protected outlet.