Nippa WB 2000 Installation And Operating Manual

Advertisement

Quick Links

Sauna Stov es
& Heaters
Since 1930
the
Supreme
INSTALLATION and OPERATING GUIDE for
HEATER MODEL
WB 2000
Nippa Sauna Stoves
Beulah, Michigan 49617
Phone (231) 882-7707
www.nippa.com

Advertisement

Table of Contents
loading

Summary of Contents for Nippa WB 2000

  • Page 1 Sauna Stov es & Heaters Since 1930 Supreme INSTALLATION and OPERATING GUIDE for HEATER MODEL WB 2000 Nippa Sauna Stoves Beulah, Michigan 49617 Phone (231) 882-7707 www.nippa.com...
  • Page 2 Undoubtedly, you have given much consideration into your decision to buy a NIPPA heater and everyone at NIPPA is proud to have a part in your family’s future comfort. Pride in craftsmanship and engineering have made your heater the finest product available today.
  • Page 3 CHIMNEYS-GENERAL • The chimney must extend at least 3’ above The chimney is one of the most important parts the highest point where it passes through the of your installation. Great care should be taken roof, and at least 2’ higher than any part of to assure that the chimney you use is adequate the roof within 10’...
  • Page 4: Heater Clearances

    The diameter of the ventilation thimble must be at least 18” (6” diameter pipe). See Figure 3. In the event that 13” NIPPA you choose not to use a ventilated thimble, all combustible material with 18” of the sides of the 8”...
  • Page 5: Electrical Installation

    Stud and Clearance Stud and Clearance Header 2” Header 2” Asbestos Board Fire Clearance Clearance Clay Fire Metal Clay Connector Connector Thimble Thimble Sheet Metal Screws Wall Wall Finish Finish Flue Lining Flue Lining Methods for connecting chimney connector (stovepipe) to chimney through wall. FIGURE 4 When the stovepipe is connected to a masonry ELECTRICAL INSTALLATION...
  • Page 6 1. Remove the 4 screws from the center back If your heater included the grate option, simply of the heater. See figure 5. build your first fire right on the grate. If you 2. Mount the fan with the motor and cord on the have the firebrick option, build directly on the right side of the heater.
  • Page 7: Creosote - Formation And Need For Removal

    CREOSOTE - FORMATION AND NEED CAUTION FOR REMOVAL When the heater is in operation, the fuel door should only be opened to take coals or When wood is burned slowly, it produces tar add fuel. Do not operate the heater with the and other organic vapors, which combine with door in an open position.
  • Page 8 S P E C I F I C A T I O N S W B - 2 0 0 0 G H e i g h t 3 5 " L e n g t h 1 9 . 5 " W i d t h 2 5 .

This manual is also suitable for:

Wb 2000g

Table of Contents