Barska BIOMETRICS iBOX User Manual

User Manual for
Biometric Lock Box
PARTS OF THE LOCK BOX
Top Of Lock Box
A. Cable Slot
B. Indicator Light
C. Fingerprint
Scanner
B
C
Bottom Of Lock Box D
Remove Cover to
Expose
D. Battery
Compartment
E. Keypad
F. Key Access
WARNING
Avoid leaving lock box door open and unattended; it will allow
unauthorized individuals to reprogram the lock box, gaining full
access to the safe and the contents.
©2016 BARSKA® | Pomona, CA 91767, USA
(t) 888.666.6769 | (f) 909.445.8169 | www.barska.com
BATTERY
1. Locate the battery compartment, it is held in by 1 screw.
Remove screw and battery compartment cover.
2. Slide battery holder out of compartment.
3. Place 4, AA batteries and pay attention to the polarity of
each battery.
4. Gently slide battery cover back into place and tighten screw.
Note: Do not mix old and new batteries.
CREATING PERSONAL PIN CODE
Lock Box Default Pin Code: 1230
Retains 1 Pin Code, 4 - 11 digits
Personal Pin Code CANNOT start with "0"
A
1. Open battery compartment and locate keypad.
2. Enter current Pin Code then press the number "3" key.
3. Insert your new Pin Code, If Pin Code is shorter than 11 digits
insert key into key lock and turn counter clockwise to complete
setup. Long beep will be heard when setup is complete.
4. Use your registered Pin Code to open the lock box. If lock box
does not open then Pin Code was not registered. Repeat
steps above to create personal pin code.
REGISTERING A FINGERPRINT
If red flashes are seen when accessing the lock box, then lock
box is in Factory Default Mode: ANY fingerprint can open the
lock box.
Retains 30 Fingerprints
1. Open battery compartment and insert key into key lock and
turn counter clockwise.
2. Place Fingerprint on Fingerprint scanner, 2 beeps will be
heard. Fingerprint is now registered to the lock box.
3. Use your registered Fingerprint to open the lock box. If lock
E F
box opens but a red light is seen and several beeps
is heard then registration was unsuccessful. Repeat steps
above to register fingerprint.
0 1
2 3
OPENING THE LOCK BOX
Internal light will active when the lid of the lock box is opened.
Fingerprint
Place Fingerprint on Fingerprint Scanner and lock box will
unlock.
Pin Code
Remove battery compartment cover. Enter in current pin code,
and lock box will unlock.
Key
Remove battery compartment cover. Insert key into key hole and
lock box will unlock.
DELETING PIN CODE/ALL FINGERPRINTS
1. Remove battery compartment cover.
2. Take 1 out battery, turn key in key hole and hold this position
in place, replace the 1 battery back into place and wait for 3
beeps. After 3rd beep lock box is reset.
Lock box is in Factory Default Mode ANY fingerprint can open
the lock box. Lock Box Default Pin Code: 1230
SOUND OPTION
To Turn Sound Off:
Turn Key in Key hole counter clock wise and hold for 5 seconds
2 Beeps will be heard and lock box is now in silent mode.
Note: Registration process and door open alarm will still have
sound.
To Turn Sound On:
Turn Key in Key hole counter clock wise and hold for 5 seconds
2 Beeps will be heard and lock box is now in audio mode.
DOOR OPEN ALARM
When lock box door is unlocked/opened, after 1 min there will be
a constant beep to remind you to close the door.
LOW BATTERY ALARM
With the lock box open and an alarm is heard and red light is
seen then battery of the unit is low. Please replace batteries as
soon as possible.
If the battery voltage is too low the lock box will not open and no
alarm will be heard.
See reverse side for more information
6/16
BC473