Page 2
Siesta i årene som kommer. quality of your Siesta for years to come Ingmar Relling LK Hjelle Møbelfabrikk AS Postboks 8, N-6230 Sykkylven Phone: +47 70 25 44 00 E-mail: office@hjelle.no www.hjelle.no...
Page 3
Assembly Instuctions Verify you have all the pieces shown Place the chair on a protective pad on the floor. Bolt the straight crossbar between and to the lowest lying laminate side with 2 bolts without tightening. Remove the rubber band and unscrew the 2 bolts.
Page 4
Assembly instructions Bolt the two curved crossbars to the lowest lying laminate side to the top of the back and the seat – 1 bolt each place. Put your foot on the lowest lying laminate side and pull the top laminate side up in position.
Page 5
Assembly instructions Put your foot on the lowest lying frame side and pull the top opposite side up until you can press the curved crossbars into the 2 metal dowels under the seat and behind the back. Then put in the bolts. Now put the last bolt into the straight crossbar and the top laminate side.
Page 6
Assembly instructions Pull the armrest over the front part of the arm frame – attach the bolt in from the inside. Tighten all the bolts. Remember to occasionally tighten all bolts. Take a Siesta!
Page 7
Removal of stains If the wood has got spots or stains, one should always first try to remove them with a cloth wrung in lukewarm water and if necessary with a mild detergent. Soap treated surfaces Difficult grease/ Remove with purified gasoline and light sanding oil spots with fine sandpaper.
Page 8
Oil treated surfaces Difficult grease/ Can be removed with mineral spirits. Oil treatment oil spots should be repeated after use of mineral spirits. Pen/marker Can be removed with a soft cloth soaked in alcohol. From such as newspaper or shoe polish, can be Dark spots removed with an eraser or fine sandpaper.