LINOVISION POE-Extender02 GP User Manual

2 Port Gigabit 802.3af/at/bt PoE Extender
User Manual
Gigabit 802.3af/at/bt PoE Ethernet Repeater, which uses advanced network cable drive and power supply technology
to extend 1000Mbps Ethernet signal to 100 meters, greatly extending the transmission distance and providing 50~57V
PoE power at the same time, the PoE output power can be up to 50W/80W. IP67-rated, industrial grade enclosure can
meet requirement of harsh environment, working temperature can be up to -40~75℃. It is widely used in security
surveillance and network projects.
Features
 Including two models:
--provide 2*10/100/1000Mbps PoE Ethernet ports:
One 802.3af/at/bt PoE input port, one 802.3af/at/bt PoE output port.
--provide 3*10/100/1000Mbps PoE Ethernet ports:
One 802.3af/at/bt PoE input port, two 802.3af/at/bt PoE output ports.
Both models can meet the requirements of 802.3bt PoE powered devices such as PTZ speed dome camera,
digital display.
 Use advanced network cable drive technology, the transmission distance can be up to 100m.
 PoE power supply is compatible with End-span and Mid-span.
 Meet standards of IEEE 802.3 10BASE-T, IEEE 802.3u 100BASE-TX, IEEE 802.3ab 1000Base-T.
 Excellent circuit isolation protection, effectively improve product's lightning protection, ESD and anti-interference
ability.
 Easy to install, special designed waterproof joint allows RJ-45 pass through directly, no need for RJ-45 assembly.
 Plug and play, no setting required.
Notice
It is recommended to use the standard Cat6 network cable (or better) to reach the optimal transmission distance.
1
────────────────────────────◀◀◀ 2 Port Gigabit PoE Extender
Board Diagram
V2.0
1 Output
2 Outputs
Installation Steps
Please check the following items before installation, if missing, please contact the dealer.
 2 Port PoE Extender
 Waterproof Joint
 User Manual
Installation steps:
1 ) Please turn off the signal source and the device's power, installation with power on may damage the device.
2) Check if the network cable and other transmission line that will be used is occupied by other device.
3) Use a network cable to connect PoE IN port of the repeater with PoE adapter or switch.
4) Use a network cable to connect PoE powered device with PoE OUT port of repeater.
5) Check if the installation is correct and device is good, make sure all the connection is reliable and power up the
system.
Notice
The PoE IN and PoE OUT Ports must be correctly connected, or the repeater will not work.
1 pcs
2pcs(1 output port repeater)/ 3pcs (2 output ports repeater)
1 pcs
2