Summary of Contents for Vannus FC-AA02/A
- Page 1 INSTRUCTION MANUAL MODEL ALT. NAME FC-AA02/A V3-3B/52 LED FC-AA04/A V3-3B/46 LED FC-AA06/A V3-3B/40 LED FC-AA07/A V3-3B/28 LED CEILING FAN Version: 2023.V1...
-
Page 2: Table Of Contents
Table of Contents Item Page No. 1. Safety Precaution ................. 1 - 2 2. Parts & Accessories ................3 3. Installation Instruction ................4 - 7 4. Power Supply Connection ..............8 5. Circuit Diagram ..................9 6. Transmitter Learning Process ...............10 7. -
Page 3: Safety Precaution
Parts & Accessories Safety Precaution STOP using the ceiling fan when any abnormality or failure occurs. If unusual oscillating movement is observed, immediately stop using the ceiling fan and contact the manufacturer, its service agent or suitably qualified persons. CAUTION Please take note of the following important points when installing. -
Page 4: Installation Instruction
Installation Instruction Installation Instruction IMPORTANT : DO NOT CONNECT THIS REMOTE CONTROL CEILING FAN TO Reinstall safety wire screw and washer, Canopy and Coupling Cover back to Downrod DIMMER SWITCH OR REGULATOR. Fix the Rubber Pulley Assembly to the Downrod with Bolt, Washer, Nut and tighten them firmly, then insert the Clevis Pin. - Page 5 Installation Instruction Installation Instruction Step 4 Step 6 Install Lamp Shade by twisting in. Remove the Safety Wire screw and washer from the Downrod. Install the Safety Cable. Safety Wire Lamp Shade Step 5 Connect the LED Light Connector. Install LED Light Kit onto Motor Assembly by screw. Step 7 Connect the Connectors from Fan and Receiver.
-
Page 6: Power Supply Connection
Installation Instruction Circuit Diagram Light Kit Step 7 Screw Below shows a complete installation diagram. Motor Orange Blue Power Supply Connection MAIN PCB Blue Neutral (Blue) Orange N LED+ IMPORTANT : DO NOT CONNECT THIS REMOTE CONTROL CEILING FAN TO Live (Brown) Brown DIMMER SWITCH OR REGULATOR. -
Page 7: Transmitter Learning Process
Transmitter Learning Process Transmitter Function The receiver & transmitter is pre-programmed in factory. If you wish to control 2 or more Fans using 1 transmitter, the below steps are required. - Light on/off & select LED colour DO NOT PRESS ANY OTHER BUTTON DURING THIS PROCESS Mount the remote control - Turn off fan holder on the wall with the... -
Page 8: Maintenance
2. Damp the cloth lightly. Use only soft or lint-free cloth to clean the fan. Rough fabric will scratch the surface. FC-AA02/A (V3-3B/52 LED) : 1320mm (4’ 4”) 3. Do not bent the blades while cleaning. At the event where blades are bent or damage, FC-AA04/A (V3-3B/46 LED) : 1165mm (3’...