Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Proteco PSE30
- Page 1 Installation Manual PSE30 PSE31 CENTRAL MOTOR FOR ROLLING SHUTTER 01_06_2023...
- Page 2 - the relevant technical documentation is compiled in accordance with part B of Annex VII of directive 2006/42/EC - the relevant technical documentation is compiled and preserved by Proteco Srl which undertakes to transmit it by mail in response to a reasoned request by the national authorities.
- Page 3 IMPORTANT SAFETY WARNINGS Do not use controls that may start the motor in oppo- site directions simultaneously. Do not control more than one opener with a single Do not allow children to operate or play with opener controls. button. Keep remote controls out of children or unauthorised users’ The product shall not be installed lower than 2.m reach.
-
Page 4: Techincal Specifications
TECHINCAL SPECIFICATIONS Intended Use PSE30 and PS31 openers are designed for any kind of rolling shutters for residential and commercial use. Use and operations not listed in this manual shall be considered forbidden and will void the warranty terms. Technical Data... -
Page 5: Installing The Product
INSTALLING THE PRODUCT Fig. 1 Fitting the motor on the shaft The installation position for the motor may vary depending on the installation area. It is up to the installer to choose the most suitable solution on an individual basis. The motor is designed for left side installation on the shaft (indoor view);... -
Page 6: Adjusting The Limit-Switches
M10x22 screw Adjusting the limit-switches 10x40 washer Please adjust limit-switches setting only when the assembling Rolling shutter screen of the motor and the electrical wiring have been completed properly. Follow below procedure for left-side mounted motor. Crown spacer Always off the main power while carrying out any adjustment for Ø... -
Page 7: Maintenance
ELECTRO-BRAKE AND RELEASE HANDLE If the motor is equipped with electro brake, insert the release cable into the Ø12 hole previously drilled on the shaft. Place the release handle in a case or easy to reach position for emergency manual release of the rolling shutter Turn the lower part of the handle COUNTER-CLOCKWISE to release the system. -
Page 8: Dismantling And Disposal
Before disposing always check with the specific laws applying in your area. DO NOT WASTE IN THE ENVIRONMENT! Proteco S.r.l. Via Neive, 77 12050 CASTAGNITO (CN) ITALY Tel. +39 0173 210111 - Fax +39 0173 210199 info@proteco.net - www.proteco.net...