BOOKSBAUM 1 & 2 STAND
ART. NR.: 716, 717, 734, 735
1
BOOKSBAUM 1
BOOKSBAUM 2
2
1.
2.
3.
3
1.
2.
4
6,5kg
6,5kg
5
DEUTSCH
herzlichen glückwunsch zum kauf ihres
BOOKSBAUM.
stecken sie die schrauben durch die
verbindungsplatte. die verbindungsplat-
te ist nicht immer gleichfarbig.
der standfuss wird von unten mit
pfosten und verbindungsplatte ver-
schraubt.
hinweis:
je nach ausführung wird der pfosten
senkrecht (booksbaum1) oder waage-
recht (booksbaum2) auf den standfuss
montiert.
1. entfernen sie die klebeschutzfolie.
2. kleben sie die vier kunststoffteile,von
unten, in die ecken des standfusses
3. pressen sie das graue kunststoffteil
in das schwarze wie gezeigt, bis es hör-
bar einrastet.
hängen sie die regalböden ein:
1. führen sie die oberen haken bis zum
anschlag komplett ein.
2. klappen sie den boden nach unten
hinweis: 1 haken unten, 2 oben.
wenn sie die regalböden eingehängt
haben, werden sie feststellen, dass
diese minimal nach oben zeigen, um
dem gewicht der bücher entgegen zu
wirken. bei bedarf können die böden
nach unten gebogen werden.
belastung pro regalboden: ca. 6,5 kg
2x
ENGLISH
congratulations on your purchase of the
BOOKSBAUM.
put the screws through the connecting
plate. connecting plate is not always of
the same color.
the foot is screwed to the pole and con-
necting plate from below.
note:
depending on the version, the pole is
mounted vertically (booksbaum1) or
horizontally (booksbaum2) on the foot.
1. remove the adhesive pro tection film.
2. tack the four plastic parts into the
corners of the standing foot from below
3. pushing the gray plastic part in the
black as shown, until it clicks into place.
hang the shelves in place:
1. insert the upper hooks up to the stop.
2. let shelf flap downwards.
note: 1 hook at the bottom, 2 at the top.
once you have mounted the shelves,
you will notice that they are slightly
pointing upwards in order to counteract
the weight of the books. if required, the
shelves can be bent downwards.
maximum load per shelf: approx. 6.5 kg
1/2