Related Manuals for Episode EVC-100R
Summary of Contents for Episode EVC-100R
- Page 1 EVC-100R & EVC-100S Volume Control Installation Guide 2 Pre-construction 3 Impedance settings 5 Installation 7 Diagram 8 Specifications...
- Page 2 Pre-construction Both the EVC-100R and the EVC-100S fit easily into the majority of 18 cubic inch single-gang boxes and rings available today. If local building code allows, use of a ring provides for the easiest installation as the full depth of the wall is accessible.
- Page 3 Wiring The EVC-100R and the EVC-100S can accommodate 14 to 22-gauge speaker wire. The longer your run, the thicker the wire should be. All in-wall and in-ceiling wire installations are subject to local code fire ratings. Never use lamp or zip cord. Always use multi-strand copper speaker wire for your installations.
- Page 4 To avoid damage, never go below an amplifier’s minimum impedance rating. Both the EVC-100R and EVC-100S have minimum impedance ratings of 4Ω. Do not exceed this minimum.
-
Page 5: Installation And Wiring
Installation and wiring Episode volume control connectors do not require screwdrivers. Simply flip the levers up on each connector before inserting the wire. Insert the wires then snap the levers down. The spring-loaded mechanism holds the wires in place. Caution: Confirm the amplifier is powered off before connecting any volume control wires to it. - Page 6 3. Verify the amplifier or receiver being used is turned off, then connect the wire coming from the amplifier to the connector labeled AMPLIFIER. 4. Verify there are no stray strands or exposed wire outside of the connector to avoid a short. Make sure the connector is tightened down on bare wire and not insulation.
- Page 7 Remove front plate To amplifier and knob for Impedance switch L- R- R+ EVC-100R To speakers To amplifier Impedance switch To speakers EVC-100S...
- Page 8 Snap One, LLC (formerly known as Wirepath Home Systems, LLC), in the United States and/or other countries. 4Store, 4Sight, Control4, Control4 My Home, SnapAV, Episode, Wirepath, and Wirepath ONE are also registered trademarks or trademarks of Snap One, LLC.