Lowering The Leader To The Leader Lift Device - JUNTTAN PM 20L Operator's Manual

JUNTTAN

6.4.2.2 LOWERING THE LEADER TO THE LEADER LIFT DEVICE

n DANGER
Always raise the leader lift device fully up (signal light H23 will light on and leader
lift device stops moving) before you start lowering the leader with forward inclination
cylinder.
• Pull the horizontal slide fully in.
• Retract the lateral inclination cylinders fully into their
minimum length.
• Power the leader lift device with the switch on the rear of
the right console and raise the leader lift device fully up by
pressing the "leader lift device up"-button (4).
• n DANGER: Do not touch the "winches/forward
inclination cylinder release"- button (1) when you raise
the leader lift device. This button is used only when the
leader is lifted with the leader lift device.
• The leader lift device will stop automatically at its top
position. Let the engine run at idle.
• Incline the leader back with the forward inclination
cylinder until it reaches the leader lift device.
• While you incline the leader down, lower the leader foot
so that it is slightly above the ground until it is at the end
of its stroke.
• If the proximity switch S108 does not function, the
forward inclination cylinder stops at the safety limit 30°
(if the inclinometer is switched off, you can not extend
forward inclination cylinder).
There are two signal lights on the top console which are important when lifting or
lowering the leader.
Green (H41): this signal light is on when the forward inclination cylinder is released
Yellow (H42): this signal light is on when leader is against the leader lift device
Daily operation section
2
H41
H42
4
1
5
3
H23
65