Download Print this page

Global Dryer GX Series Owner's Manual

Advertisement

Quick Links

DISCONNECT POWER BEFORE INSTALLING
WARNING:
DESUNA LA ELECTRICIDAD ANTES DE HACER REPARACIONES
INSTALLATION INSTRUCTIONS
1. Remove cover by removing (2) tamper proof-screws using security wrench
supplied. Pull cover directly toward you. IMPORTANT: Save security wrench.
2. Dryers should be placed at least 2 feet (61cm) apart and at least 12" (30cm) from
washbasin. Do not install dryer over washbasin. Automatic dryers should be at least
18" (46cm) above any projection which may interfere with the operation of the auto-
matic sensor.
Hold the backplate to the wall at the suggested mounting height. Measure from bot-
tom edge of backplate to the floor (Ref. Dimension "A", Fig. 1):
MEN
WOMEN
44" (112cm)
42" (107cm)
3. Mark the locations of the four mounting holes and the conduit entrance location on the
wall. (The conduit entrance is the proper hole diameter for 1/2 inch (13mm) conduit.)
4. Fasten the backplate to the wall where previously marked.
RECOMMENDATION:
Wood wall – No. 14 (M6) wood screws, 2 3/4" (70mm) long
Cement or brick – 1/4" (M6) stud expansion bolts, 3" (76mm) long
Hollow wall – 1/4" (M6) toggle bolts, length depends on wall thickness
5. Run service wire to the dryer location and connect to lead wires.
IMPORTANT: All units must be supplied with 3 wire service. Use No. 12 or 14 wire
as required by local electrical code. The ground wire must be connected to the dryer
ground screw. Unit must be installed by a qualified licensed electrician.
CONNECT TO A DEDICATED CIRCUIT NOT TO ExCEED 20 AMPS.
Dryers located in shower rooms or other wet locations should be equipped with
ground fault interrupter(s).
6. Carefully replace the cover using (2) tamper-proof screws supplied. Apply a bead of
caulk around edges of cover to wall.
7/16
8 15/16
(11mm)
(227MM)
6 3/16
(208mm)
8 7/16
7/16
(214mm)
(11mm)
"A"
FLOOR
F
1 - d
M
igure
ryer
ouNtiNg
CHILDREN
(depends on age)
DISABLED
32 to 42" (81-107cm)
36" (91cm)
MOUNTING HOLES FOR
1/4" (M6) DIA. SCREWS
1 7/8
(48mm)
7/8 (22mm) DIA. IN-WALL
& SURFACE CONDUIT
ENTRANCES
O
'
M
GX S
wner
s
anual
F
I
or
nstallatIon or
a
ssIstance
(734) 421-2400
Email: sales@americandryer.com
I
:
mPortant
H
ave
m
#______ s
odel
GLOBAL DRYER LIMITED WARRANTY
All parts of the Gx-M/C models are warranted to the original consumer purchaser
to be free from defects in material and workmanship for a period of five (5) years or
three (3) years for Gx models from the date of purchase from manufacturer. Sensor
warranty three (3) years in the U.S.A. All models outside of the U.S.A., one (1) year
including sensor. We will replace FREE OF CHARGE, during the warranty period, any
warranted part which proves defective in material and/or workmanship under normal
installation, use, and service, excluding normal wear. Replacement parts can be
obtained by returning the part, TRANSPORTATION CHARGES PREPAID. You must
notify factory prior to returning part or dryer. Any damage to this dryer as a result of
misuse, abuse, neglect, accident, improper installation, unauthorized repairs, or any
other use violative of instructions furnished by us, WILL VOID THIS WARRANTY.
THIS LIMITED WARRANTY IS THE SOLE WARRANTY ON OUR PRODUCTS, AND
WE DISCLAIM AND EXCLUDE ANY AND ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE. OUR LIABILITY SHALL NOT EXCEED
IN ANY EVENT THE REPLACEMENT OR SALE PRICE OF THE ALLEGEDLY
NONCONFORMING PRODUCT AND SHALL EXCLUDE LABOR CHARGES. TO
THE EXTENT PERMITTED BY LAW WE SHALL NOT BE LIABLE FOR ANY LOSS,
COST, EXPENSE, OR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY
KIND, WHETHER BASED UPON WARRANTY (EXPRESS OR IMPLIED), CONTRACT,
NEGLIGENCE OR STRICT LIABILITY AND ARISING IN ANY WAY IN CONNECTION
WITH THE DESIGN, MANUFACTURE, SALE, USE OR REPAIR OF THE PRODUCT.
GLOBAL DRYER
MFD by AMERICAN DRYER, INC.
33067 INDUSTRIAL ROAD, LIVONIA, MI 48150, U.S.A.
Telephone (734) 421-2400 • Fax (734) 421-5580
www.americandryer.com • Email: sales@americandryer.com
Revised November 2011
H
D
eries
and
ryers
s
ervIce
P
c
lease
all
or
M
& S
N
. r
odel
erial
o
eady
#______
erIal
®

Advertisement

loading

Summary of Contents for Global Dryer GX Series

  • Page 1 4. Fasten the backplate to the wall where previously marked. RECOMMENDATION: GLOBAL DRYER LIMITED WARRANTY Wood wall – No. 14 (M6) wood screws, 2 3/4” (70mm) long Cement or brick – 1/4” (M6) stud expansion bolts, 3” (76mm) long All parts of the Gx-M/C models are warranted to the original consumer purchaser Hollow wall –...
  • Page 2 DISCONNECT POWER BEFORE INSTALLING WARNING: DESUNA LA ELECTRICIDAD ANTES DE HACER REPARACIONES SERVICE AND MAINTENANCE OF YOUR DRYER GENERAL OPERATION This dryer is activated by an infrared sensor. The dryer operates as long as hands are below nozzle. There is a maximum 60 second running time with a safety over-ride feature, if hands are not removed.

This manual is also suitable for:

Gx1-mGx1-cGx1