Advertisement
Quick Links
O
S
C
klahOma
Ound
OrpOratiOn
optional equipment
Additional Units (sold separately)
table top lectern / #22
This versatile, portable table top lectern,
can be used on its own or as a floor
lectern with the optional base (sold sepa-
rately). 5/8" stain and scratch resistance
thermofused melamine laminate on MDF.
Paper/book stop included.
Dimensions: 233/4" W x 133/4" H x 197/8" D
available color options
Medium Oak • Light Oak • Mahogany • Walnut
brass reading lamp / #brl
Attach an elegant brushed brass reading lamp
to the reading table of your new Speaker Stand.
Not only will you shed light on the subject, but
you will add pizzaz to your new stand.
For these and other OSC accessories, please contact your dealer, or:
oklahoma sound corp.
149 Entin Road, Clifton, NJ 07014
Tel 973-594-9000 • Fax 973-594-9339
www.oklahomasound.com • email: info@oklahomasound.com
Full Floor lectern / #222
Attractive and durable lectern made of 5/8"
stain and scratch resistant thermofused
melamine laminate on MDF. Full sized
reading surface, shelf and paper/book
stop built in. Floor glides provided.
Dimensions: 23" W x 461/2" H x 16"D
A/V Cart
[Combo Lectern Base]
assembly manual
model #112
Advertisement
Related Manuals for Oklahoma Sound 112
Summary of Contents for Oklahoma Sound 112
- Page 1 Not only will you shed light on the subject, but you will add pizzaz to your new stand. For these and other OSC accessories, please contact your dealer, or: oklahoma sound corp. 149 Entin Road, Clifton, NJ 07014 Tel 973-594-9000 • Fax 973-594-9339 model #112 www.oklahomasound.com •...
- Page 2 The casters are attached to a metal channel called a u-clip. About an inch into the wood, at the four The model #112 Combo Lectern Base - A/V Cart Con- bottom edges there are pre-drilled holes, these are verts the TABLE TOP to a FULL FLOOR lectern or use there for the purpose of screwing the casters in place.
- Page 3 Ound OrpOratiOn A/V CART: Model 112 assembly instructions 3) Align the bolts on the front of Panel B sides with the cams on both side panels, tighten cams (Diagram D). assembly tips Notice Panel B is about an inch taller that the rest of the •...
- Page 4 Ound OrpOratiOn A/V CART: Model 112 assembly oF lectern installation oF hardware 1) Lay out the wood panels as shown below in figure "A" (make It is important that the instructions on the assembly are sure the factory drilled holes are facing upwards).