Summary of Contents for Tecnoinox PFR8V7/1
- Page 1 CODE 716084 MODEL PFR8V7/1 DESCRIPTION 4 ROUND HERMETIC HOT PLATES ELECTRIC ON GN1/1 ELECTRIC CONVECTION OVEN WITH 1 GRID (DIAM 22CM - 8.7IN) 13-03-2023 12:11...
- Page 2 Part 1 – Installation COOK TOPS AND ELECTRICAL COOKERS WITH ELECTRIC OVEN General warnings Install the appliance on a floor or flat The manufacturer declines any liability surface. Avoid slopes of more than 5° to keep for damage caused by improper or incorrect it stable.
- Page 3 The surfaces in contact with the (labelled A in the figure below). Follow the appliance must be covered with heat- relevant instructions to fit them. The bracket insulating material. is provided, and can also be ordered at a later date. To prevent accidental contact with hot parts, fit the 2 thermal protection plates (labelled B in the figure below) on the sides...
- Page 4 The appliance power supply must be protected against overcurrent (short circuits and overload) with fuses or properly sized circuit breakers. The installer must connect up the appliance by positioning an easily accessible main switch that disconnects all poles supplying electrical power to the appliance. When contacts are open, there must be a minimum distance of 3 mm between the poles.
- Page 5 Part 2 – Use General warnings Be careful when using the appliance appliance designed because the cooking surfaces are very hot. professional use and therefore should only be used by qualified personnel. The plates are provided with a temperature limiter that stops the electricity Be careful when using the appliance supply when the temperature reaches because the cooking surfaces are very hot.
-
Page 6: Safety Thermostat
Switching on the fan electric oven Turn the thermostat dial “D” to the desired cooking temperature marker. The green indicator light “E” lights up to indicate that the machine is powered up and the fans are running. The orange indicator light “F” lights up to indicate that the heating elements are in operation. - Page 7 Part 3 – Maintenance and cleaning Replacing parts Faulty parts should only be replaced by qualified personnel. First, always disconnect the appliance from the gas and electric mains. After having removed the control panel, all the functional parts of the appliance are easily accessible. Only order spare parts from the manufacturer or an authorised dealer.
-
Page 8: Ecology And The Environment
Cleaning and care Only clean the appliance once it has then dry them using a soft, dry cloth. For stubborn deposits, use hot water and vinegar. Do not use harsh or abrasive detergents to cooled. clean the stainless steel parts. Do not use iron cleaning pads as they Only use products that are food safe.